PCPeng Chen

Peng Chen

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Peng Chen has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Experimental and Numerical Study on Local Buckling Analysis of Q550 High-Strength Steel T-Rib-Stiffened Plates

    by Peng Chen, Qingtian Su, Yongcheng Lu, Sizhe Wang, Yanhong Chen

    In high-strength steel structures, local plate buckling is a critical concern due to the slenderness of plate elements. This study experimentally and numerically investigated the local buckling analysis of Q550 high-strength steel stiffened plates with T-ribs under compression. Five specimens with different base-plate slenderness were fabricated and subjected to uniaxial compression loading tests. The base plate of all specimens exhibited significant local out-of-plane deformation, and the T-ribs experienced varying degrees of in-plane and out-of-plane deformations. The buckling strength of the specimens decreases with increasing base-plate slenderness. The residual stresses and initial geometric imperfections of the high-strength steel stiffened plate were experimentally measured. Finite element (FE) models incorporating the residual stresses and initial geometric imperfections were established to simulate the buckling behavior of the stiffened plates. The FE models were validated against the experimental results and a parametric study was further conducted. The numerical results indicate that both residual stresses and initial geometric imperfections have a moderate influence on the buckling strength. Furthermore, the formulations in several national design codes used to account for local buckling effects were evaluated. The Eurocode provides approximate predictions, while the Chinese code and Japanese code provide conservative estimations.


  • Open Access

    Overall Buckling Behavior and Design of Steel Stiffened Box Section Columns Under Axial Compression

    by Bing Shangguan, Jie Li, Qiu Zhao, Peng Chen, Furong Ruan, Huiteng Pei

    This study experimentally and numerically investigated the overall buckling behavior of steel box column components. Two box section specimens were fabricated for axial compression tests. Prior to the tests, the material properties, initial geometric imperfections and residual stress were measured. In addition, an extended parameter analysis was conducted using a finite element model validated by experimental results to evaluate the impact of geometric defects and residual stresses on the bearing capacity of unstiffened and stiffened box section columns. A novel column curve was proposed based on massive datasets of parametric models. The short and long column specimens exhibited typical strength failure and buckling failure modes, respectively. The initial geometric imperfections and residual stresses slightly reduced the buckling strength from the models, with a maximum reduction in buckling strength owing to initial geometric imperfections of 5.2% and that owing to residual stresses of 6.52%. The unstiffened and stiffened box columns have the same stability coefficient when the slenderness ratio is the same. Additionally, the ultimate load capacity calculation formula for stiffened box columns proposed in this paper averages 2.20% higher than Class C curves in JTG D64-2015, lies between Japanese and U.S. codes, and demonstrates good accuracy.