Investigation on Mechanical and Fracture Behavior of Magnesium Composite Reinforced With Hybrid Fly Ash Particulates Synthesized via Friction Stir Processing Route
- 26 February 2024
- journal article
- research article
- Published by ASME International in Journal of Engineering Materials and Technology
- Vol. 146 (3) , 1-28
Abstract
Utilizing waste materials like fly ash in the creation of lightweight magnesium metal matrix composites with a high strength-to-weight ratio is encouraged by the rising demand for in-expensive reinforcements. In the current study, friction stir processing (FSP) was employed to synthesize magnesium surface composites via incorporating hybrid reinforcement particles, including nano titanium carbide and fly ash. The synthesized composite material underwent examination through microscopic images of the stir zone and assessments of microhardness, tensile strength, compressive strength, electrical and thermal conductance, and wear behavior. The results revealed a notable refinement in grain size and a simultaneous improvement in mechanical properties. Notably, there was a substantial increase in wear resistance attributed to the increased hardness and uniform dispersion of hybrid reinforcements within the surface composite. The results demonstrate that the inclusion of reinforcements in magnesium-based alloy led to an enhancement in fracture toughness, mitigation of crack propagation, and an overall improvement in fracture resistance to catastrophic failure.Keywords
This publication has 42 references indexed in Scilit:
- Investigation on Mechanical and Wear Properties of ZE43 Magnesium Composites Reinforced with Silicon Nitride by Friction Stir ProcessingSilicon, 2022
- Investigation on Mechanical and Tribological Characteristics Cu/Si3N4 Surface Composite Developed Through Friction Stir ProcessingSilicon, 2021
- Machining characteristics, wear and corrosion behavior of AZ91 magnesium alloy ‐ fly ash composites produced by friction stir processingMaterialwissenschaft und Werkstofftechnik, 2021
- Effect of mono and hybrid ceramic reinforcement particles on the tribological behavior of the AZ31 matrix surface composites developed by friction stir processingCeramics International, 2020
- Low cost metal matrix composites based on aluminum, magnesium and copper reinforced with fly ash prepared using friction stir processingComposites Communications, 2018
- Effect of nano ZrO2 on strengthening and electrical properties of Cu-matrix nanocomposits prepared by mechanical alloyingCeramics International, 2017
- Evaluation of tensile strength and fracture behavior of friction welded dissimilar steels under different rotational speeds and axial pressuresSādhanā, 2015
- Investigation of mechanical properties of friction-welded AISI 304 with AISI 1021 dissimilar steelsThe International Journal of Advanced Manufacturing Technology, 2014
- Experimental study of mechanical properties of friction welded AISI 1021 steelsSādhanā, 2013
- Thermal Conductivity of SiC Reinforced Magnesium Matrix Composites2000