On the Behavior of Hot Crack Formation During Solidification in Fe–Ni Alloys
Authors:
- 5 February 2003
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 5 (1-2) , 66-77
Abstract
The behavior of hot crack (tearing) mechanism during solidification in two Fe–Ni alloys. The mechanical properties during solidification, with focus on their hot crack (tearing) behavior, were investigated by tests on “in‐situ” solidified samples. Hot cracking susceptibility was determined by using the transition temperature for area reduction (hot ductility), e.g., the transition temperature between brittle and ductile fractures. The results of the tensile tests are compared with the liquidus and solidus temperatures, measured by thermal analysis.Keywords
This publication has 10 references indexed in Scilit:
- On the mechanism of liquid copper penetration into iron grain boundariesScandinavian Journal of Metallurgy, 2001
- Solidification Mechanism of Unmodified and Strontium Modified Al–Si AlloysMaterials Transactions, JIM, 2000
- A new hot-tearing criterionMetallurgical and Materials Transactions A, 1999
- Effect of Vacancies and Alloying Ordering on the Thermodynamics during Solidification ProcessingMaterials Transactions, JIM, 1998
- The Influence of Lattice Defects on the Solidification Process of Al-Cu Alloys.ISIJ International, 1995
- Rapidly solidified ribbons of Fe2C13Cr1SiMo alloys produced by the planar flow melt spinning processMaterials Science and Engineering: A, 1993
- Environmentally assisted cracking: Overview of evidence for an adsorption-induced localised-slip processActa Metallurgica, 1988
- The effect of melt composition on solidification cracking of steel, with particular reference to continuous castingMetallurgical Transactions B, 1982
- The ductility of continuously-cast steel near the melting point—hot tearingMetallurgical Transactions B, 1979
- A first report on deformation-mechanism mapsActa Metallurgica, 1972