A Hybrid Piezoelectric–Capacitive MEMS Microphone With Peripheral Electrostatic Transduction
- 21 January 2026
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Electron Devices
- Vol. 73 (3) , 1573-1578
Abstract
This work proposes a piezoelectric –capacitive dual-mode micro-electromechanical system (MEMS) microphone with peripheral electrostatic transduction. Finite element analysis is used to investigate the contribution of the peripheral electrode configuration to the response characteristics of the proposed piezoelectric–capacitive MEMS microphone (PCMM). Piezoelectric transduction is achieved using a conventional piezoelectric stack with multiple layers. The capacitive transduction part is implemented through a peripheral electrode formed by the overlapping circumferential region between the silicon substrate and the device layer. The proposed PCMM shows a measured sensitivity of −51.1 dB (1 V/Pa) and a signal-to-noise ratio (SNR) of 49.6 dB at 1kHz (1 Pa) for the piezoelectric part, and −51.3 and 68.9 dB at 1kHz, respectively, for the capacitive part. Through the integration of dual outputs from the above two modes, the hybrid mode achieves measured sensitivities and SNR of −45.3 dB (1 V/Pa) and 55.3 dB (1kHz). The A-weighted SNR in the piezoelectric, capacitive, and hybrid modes is 10.53, 30.58, and 16.27 dB(A), respectively. At 145.6-dB SPL, the hybrid mode shows lower total harmonic distortion (THD) (1.7%) than the piezoelectric (2.6%) and capacitive (2.3%) modes.Keywords
Funding Information
- China Scholarship Council (CSC 202006320040)
- Micro- and Nano-Systems Group Headed by Prof
This publication has 29 references indexed in Scilit:
- Flexible micromachined ultrasound transducers (MUTs) for biomedical applicationsMicrosystems & Nanoengineering, 2025
- Piezoelectric MEMS microphones based on rib structures and single crystal PZT thin filmMicrosystems & Nanoengineering, 2024
- A piezoelectric MEMS microphone with proof mass and its arraySensors and Actuators A: Physical, 2024
- MEMS-based piezoresistive and capacitive microphones: A review on materials and methodsMaterials Science in Semiconductor Processing, 2023
- Stress analysis of circular membrane-type MEMS microphones with piezoelectric read-outSensors and Actuators A: Physical, 2022
- Piezoelectric MEMS based acoustic sensors: A reviewSensors and Actuators A: Physical, 2020
- Squeeze film damping and stiffening in circular CMUT with air-filled cavity: Influence of the lateral venting boundary conditions and the bias voltageSensors and Actuators A: Physical, 2017
- Design and characterization of high sensitive MEMS capacitive microphone with fungous coupled diaphragm structureMicrosystem Technologies, 2015
- Silicon microphone development and applicationSensors and Actuators A: Physical, 2007
- Piezoelectric properties of polycrystalline AlN thin films for MEMS applicationSensors and Actuators A: Physical, 2006