A Fully Soft Switched Point-of-Load Converter for Resource Constraint Drone Applications
- 17 July 2019
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 35 (3) , 2705-2713
Abstract
The power efficiency and weight of present point-of-load (POL) dc–dc converters for drone applications are often compromised because they suffer from large switching losses at continuous conduction mode for heavy loads and excessive hardware overheads at discontinuous conduction mode for light loads. This paper presents a boundary conduction mode (BCM) control scheme for POL converters embodying a single operation mode. This is achieved by means of a hysteresis voltage controller to turn on / off the output power stage when necessary. The proposed BCM control scheme achieves high power efficiency (≥91.2%) over a wide load range (5 mA–1 A) by means of fully soft switching. Specifically, a hysteretic current controller is proposed to realize ZCS, and an adaptive dead time controller is proposed to realize ZVS. Further, the proposed BCM control scheme requires a small output inductor (0.82 μH) by means of designing the customizable peak inductor current. To verify the proposed BCM control scheme, we realize a BCM-based POL converter that features an input voltage range of 5–16 V, output voltage range of 2.5–8 V, switching frequency of 1.5 MHz, peak power efficiency of 96.8%, and ≤35 mV output voltage undershoot/overshoot for 1-A load step. When being benchmarked against state-of-the-art counterparts, the proposed design features the lowest voltage undershoot/overshoot, the highest switching frequency, ∼5.7× smaller inductor, and ∼11% higher power efficiency at light loads.Keywords
This publication has 18 references indexed in Scilit:
- Boundary Conduction Mode Control of a Boost Converter With Active Switch Current-Mirroring SensingIEEE Transactions on Power Electronics, 2017
- A 30-W 90% Efficiency Dual-Mode Controlled DC–DC Controller With Power Over Ethernet Interface for Power DeviceIEEE Transactions on Very Large Scale Integration (VLSI) Systems, 2017
- Unified Boundary Trapezoidal Modulation Control Utilizing Fixed Duty Cycle Compensation and Magnetizing Current Design for Dual Active Bridge DC–DC ConverterIEEE Transactions on Power Electronics, 2016
- Switching Battery Charger Integrated Circuit for Mobile Devices in a 130-nm BCDMOS ProcessIEEE Transactions on Power Electronics, 2016
- High Frequency Buck Converter Design Using Time-Based Control TechniquesIEEE Journal of Solid-State Circuits, 2014
- Proposed Switching Losses Model for Integrated Point-of-Load Synchronous Buck ConvertersIEEE Transactions on Power Electronics, 2014
- High-Density Integration of High-Frequency High-Current Point-of-Load (POL) Modules With Planar InductorsIEEE Transactions on Power Electronics, 2014
- High-Frequency Integrated Point-of-Load Converters: OverviewIEEE Transactions on Power Electronics, 2013
- High-Density Low-Profile Coupled Inductor Design for Integrated Point-of-Load ConvertersIEEE Transactions on Power Electronics, 2013
- Design and Evaluation of a High-Frequency LTCC Inductor Substrate for a Three-Dimensional Integrated DC/DC ConverterIEEE Transactions on Power Electronics, 2012