Evaluation of wood fiber composites based on a novel simultaneous defibration and compounding process
- 23 October 2017
- journal article
- research article
- Published by Wiley in Journal of Applied Polymer Science
- Vol. 135 (7)
Abstract
The distinctive length and morphology characteristics of thermomechanical produced wood fibers make it a promising candidate for the utilization in polymer composites. However, due to the low bulk density of these fibers, the feeding into the compounding process (i.e., extruders) is quite challenging. In this study, a novel simultaneous defibration and compounding process are conducted in order to solve the feed‐in problem of thermomechanical fibers. A disc‐refiner was used to defibrate wood chips to fibers and compound the fibers with neat polymer granulates in one process step. After the process, the material showed typically thermomechanical fibers with chopped polymer particles which were inseparably attached to the fiber. The observed mechanical properties of the composites were slightly lower than some literature values. With field emission scanning electron microscopy and X‐ray microtomography analysis, voids and a polymer enriched surface were found influencing the composites performance. © 2017 Wiley Periodicals, Inc. J. Appl. Polym. Sci. 2018, 135, 45859.Keywords
This publication has 22 references indexed in Scilit:
- Critical factors on manufacturing processes of natural fibre compositesComposites Part B: Engineering, 2012
- The Effect of Processing on Fiber Dispersion, Fiber Length, and Thermal Degradation of Bleached Sulfite Cellulose Fiber Polypropylene CompositesJournal of Thermoplastic Composite Materials, 2009
- Extrusion-based wood fibre–PP composites: Wood powder and pelletized wood fibres – a comparative studyComposites Science and Technology, 2008
- Wood–plastic composites as promising green-composites for automotive industries!Bioresource Technology, 2008
- Fundamental studies on wood–plastic composites: Effects of fiber concentration and mixing temperature on the mechanical properties of poplar/PP compositePolymer Composites, 2008
- Preparation and characteristics of composites of high‐crystalline cellulose with polypropylene: Effects of maleated polypropylene and cellulose contentJournal of Applied Polymer Science, 2002
- Stiffness behaviour of injection moulded short glass fibre/impact modifier/polypropylene hybrid compositesJournal of Materials Processing Technology, 1999
- The effect of chemical composition of interphase on dispersion of cellulose fibers in polymers. I. PVC‐coated cellulose in polystyreneJournal of Applied Polymer Science, 1993
- Microstructure of long‐ and short‐fiber reinforced injection molded polyamidePolymer Composites, 1993
- Wood fibers as reinforcing fillers for polyolefinsPolymer Engineering & Science, 1984