Porous TiN Ceramics Fabricated by Carbothermal Reduction Method
- 1 February 2013
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 745-746, 667-672
Abstract
Porous TiN ceramics with high porosity and uniform pore structure was prepared following the carbothermal reduction reaction between TiO2 and carbon. Influences of sintering additives and particle size of TiO2 on the microstructure and mechanical properties of porous TiN ceramics were investigated. Microstructure and mechanical properties of porous TiN ceramics were studied by XRD, SEM and three-point bending measurement. XRD analysis proved that the TiN phase has completely formed after reaction. In addition, SEM analysis showed that the resultant porous TiN ceramics were composed of fine grains with uniform pore structure. The addition of La2O3 not only accelerated the densification of porous TiN ceramics, but also decreased the porosity and increased the flexural strength. With a decrease in TiO2 particle size, the linear shrinkage increased and the porosity decreased accordingly.Keywords
This publication has 5 references indexed in Scilit:
- Biomorphic TiN/C ceramics prepared by reduction–nitridation of charcoal/titania compositeJournal of Materials Science, 2007
- Reaction-bonded titanium nitride ceramicsJournal of the European Ceramic Society, 1996
- Thermite reactions: their utilization in the synthesis and processing of materialsJournal of Materials Science, 1993
- Silicon Nitridation1983
- Effect of Porosity on Physical Properties of Sintered AluminaJournal of the American Ceramic Society, 1956