Enhancement of Mechanical Properties of Composites through Incorporation of CNT in VARTM - A Review
- 1 March 2010
- journal article
- research article
- Published by SAGE Publications in Journal of Reinforced Plastics and Composites
- Vol. 29 (18) , 2782-2807
Abstract
Some issues and development in the vacuum-assisted resin transfer molding (VARTM) technique and the use of carbon nanotubes (CNT) as additional reinforcement in laminated composite are discussed in this article. There has been considerable interest in the incorporation of CNT as secondary reinforcement in addition to the primary fiber reinforcement in laminated composites. The use of CNT is apparently able to enhance the out-of-plane material properties by improving interlaminar strength and fracture toughness of laminated composites. The addition of CNT may be done through the VARTM technique, a non-autoclave, relatively low-cost method, frequently used to fabricate parts with complex shapes. This survey shows that while the matrix-dominated interlaminar fracture toughness and shear properties may be improved, the improvement in in-plane fiber-dominated properties is very modest.Keywords
This publication has 51 references indexed in Scilit:
- A multi-segment injection line and real-time adaptive, model-based controller for vacuum assisted resin transfer moldingComposites Part A: Applied Science and Manufacturing, 2007
- Correlation of void distribution to VARTM manufacturing techniquesComposites Part A: Applied Science and Manufacturing, 2007
- Flow rate control during vacuum-assisted resin transfer molding (VARTM) processingComposites Science and Technology, 2006
- Analysis of the vacuum infusion moulding process: I. Analytical formulationComposites Part A: Applied Science and Manufacturing, 2005
- Three-dimensional features of void morphology in resin transfer molded compositesComposites Science and Technology, 2005
- Characterization of preform permeability in the presence of race trackingComposites Part A: Applied Science and Manufacturing, 2004
- Use of Resin Transfer Molding Simulation to Predict Flow, Saturation, and Compaction in the VARTM ProcessJournal of Fluids Engineering, 2004
- Enhancement of flow in VARTM using localized induction heatingComposites Science and Technology, 2003
- Vacuum injection moulding for large structural applicationsComposites Part A: Applied Science and Manufacturing, 2003
- Analysis of vacuum bag resin transfer molding processComposites Part A: Applied Science and Manufacturing, 2001