Silicon Tunnel Junctions Produced by Ion Implantation and Diffusion Processes for Tandem Solar Cells
- 18 September 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal of Photovoltaics
- Vol. 8 (6) , 1436-1442
Abstract
This work reports on the fabrication of silicon tunnel junctions that can be used in silicon-based bottom cells for tandem solar cells. The tunnel junction was formed on n-type monocrystalline silicon wafers using the following two different processes: 1) a thermal diffusion of boron followed by an arsenic ion implantation; and 2) successive implantation steps of boron and arsenic ions. For both the processes, a rapid thermal annealing step was used to activate the dopants and cure the defects generated by the ion implantation. The activated dopant distribution across the tunnel junction was determined by electrochemical capacitance–voltage (ECV) measurements. The quality of the device was assessed from the peak-to-valley ratio and peak current density of its current–voltage characteristics, as well as the resistivity. As a significant result, a peak current density value and a peak-to-valley ratio of approximately 50 A/cm2 and 1.7, respectively, were obtained for two consecutive implantations of boron and arsenic, followed by thermal annealing at 925 °C for 30 min. A very narrow depletion zone of 3.9 nm was calculated from the ECV dopant concentrations measurements under full depletion approximation. Finally, solar cells fabricated using this optimized process resulted in a conversion efficiency of 10.1% against 12% obtained from the reference monocrystalline solar cell.Keywords
Funding Information
- Agence National de Recherche
- NOVAGAIN (ANR-12-PRGE-0014)
This publication has 18 references indexed in Scilit:
- Achievement of More Than 25% Conversion Efficiency With Crystalline Silicon Heterojunction Solar CellIEEE Journal of Photovoltaics, 2014
- High-Throughput Ion-Implantation for Low-Cost High-Efficiency Silicon Solar CellsEnergy Procedia, 2012
- Series resistance characterization of industrial silicon solar cells with screen‐printed contacts using hotmelt pasteProgress in Photovoltaics: Research and Applications, 2007
- Modelling and simulation of InGaP solar cells under solar concentration: Series resistance measurement and predictionSolid State Sciences, 2006
- SiGe Esaki tunnel diodes fabricated by UHV-CVD growth and proximity rapid thermal diffusionElectronics Letters, 2004
- 151 kA/cm 2 peak current densities in Si/SiGe resonant interband tunneling diodes for high-power mixed-signal applicationsApplied Physics Letters, 2003
- Boron diffusion from a spin-on source during rapid thermal processingJournal of Non-Crystalline Solids, 1999
- Direct evidence of arsenic clustering in high dose arsenic-implanted siliconApplied Physics Letters, 1984
- Series Resistance Analysis of Concentrator Cells under High Injection Conditions1982
- Tunnel and excess currents in stressed Esaki diodesSolid-State Electronics, 1967