Room temperature UV adhesive bonding of CE devices
- 25 July 2008
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Lab on a Chip
- Vol. 8 (9) , 1564-1569
Abstract
A simple low temperature adhesive ‘stamp-and-stick’ bonding procedure for lab-on-a-chip glass devices has been tested for capillary electrophoresis applications. This technique involves use of a mask aligner to transfer a UV-curable adhesive selectively onto the top CE substrate which is then aligned with and bonded to the bottom CE wafer. The entire bonding process can be carried out at room temperature in less than 30 minutes, involved only user-friendly laboratory operations, and provided a near 100% success rate. CE microchips made in this manner exhibited similar electroosmotic flow and separation characteristics as ones made via conventional high temperature thermal bonding. Equally important, the devices provided stable long-term performance over weeks of use, encompassing hundreds of individual CE runs without structural failure or any apparent change in operating characteristics. Finally, these devices exhibited excellent chip-to-chip reproducibility. Successful adaptation of the stamp-and-stick approach did require the development and testing of new but easily implemented structural features which were incorporated into the chip design and whose nature is described in detail.Keywords
This publication has 21 references indexed in Scilit:
- Development of a microfluidic biosensor for detection of environmental mycobacteriaSensors and Actuators B: Chemical, 2007
- Bonding of glass-based microfluidic chips at low- or room-temperature in routine laboratorySensors and Actuators B: Chemical, 2006
- Bonding of soda-lime glass microchips at low temperatureMicrofluidics and Nanofluidics, 2006
- A low temperature bonding of quartz microfluidic chip for serum lipoproteins analysisBiomedical Microdevices, 2006
- Capillary batch injection – A new approach for sample introduction into short-length capillary electrophoresis with electrochemical detectionElectrochemistry Communications, 2006
- Chemomechanics of Surface Stresses Induced by DNA HybridizationLangmuir, 2005
- Integration of microfluidics with a four-channel integrated optical Young interferometer immunosensorBiosensors and Bioelectronics, 2005
- Design and development of microfabricated capillary electrophoresis devices with electrochemical detectionAnalytica Chimica Acta, 2004
- Fabrication of a microfluidic chip by UV bonding at room temperature for integration of temperature-sensitive layersJournal of Micromechanics and Microengineering, 2003
- Room temperature bonding of micromachined glass devices for capillary electrophoresisSensors and Actuators B: Chemical, 2000