Study on the Hot Deformation Behavior of Stainless Steel AISI 321
Open Access
Abstract
In this study, the hot deformation behavior of austenitic Ti-modified AISI 321 steel with a relatively high content of carbon (0.07 wt.%) and titanium (0.50 wt.%) was studied in the temperature range of 1000–1280 °C and strain rates in the range of 0.01–1 s−1. Hot deformation was carried out with uniaxial compression of cylindrical specimens on a Gleeble 3800 thermomechanical simulator. It is shown that the flow stress increased with a decrease in the deformation temperature and an increase in the strain rate. The shape of the stress-strain curves indicates that, at high temperatures and low strain rates, the hot deformation of AISI 321 steel was accompanied by dynamic recrystallization. The passage of dynamic recrystallization was confirmed by microstructural studies. Hyperbolic sine type of constitutive equation with deformation activation energy Q = 444.2 kJ·mol−1 was established by analyzing the experimental flow stresses. The power-law dependences of the critical strain necessary for the onset of dynamic recrystallization and the size of recrystallized grains on the Zener–Hollomon parameter were established. The value of the parameter Z = 5.6 × 1015 was determined, above which the dynamic recrystallization was abruptly suppressed in the steel under study. It is speculated that the suppression of dynamic recrystallization occurs due to dispersed precipitates of titanium carbonitrides.Keywords
This publication has 32 references indexed in Scilit:
- Effect of hot working on dynamic recrystallisation study of as-cast austenitic stainless steelMaterials Science and Engineering: A, 2012
- Constitutive relationships for hot deformation of austeniteActa Materialia, 2011
- Recent developments in stainless steelsMaterials Science and Engineering: R: Reports, 2009
- Effect of initial grain size on dynamic recrystallization in high purity austenitic stainless steelsActa Materialia, 2005
- Hot working of two AISI 304 steels: a comparative studyMaterials Science and Engineering: A, 2003
- Modeling the evolution in microstructure and properties during plastic deformation of f.c.c.-metals and alloys – an approach towards a unified modelMaterials Science and Engineering: A, 2002
- Constitutive analysis in hot workingMaterials Science and Engineering: A, 2002
- Nucleation kinetics of Ti carbonitride in microalloyed austeniteMetallurgical Transactions A, 1989
- Flow stress, subgrain size, and subgrain stability at elevated temperatureMetallurgical Transactions A, 1977
- Hot WorkabilityInternational Materials Reviews, 1972