Evaluation of Polymer Materials for MEMS Microphones
- 27 May 2022
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in Journal of Microelectromechanical Systems
- Vol. 31 (4) , 673-682
Abstract
Polymers are attractive materials for the fabrication of micro-electro-mechanical system (MEMS) microphones because of their low Young’s moduli, generally lower processing temperatures than silicon, and simple fabrication; such microphones are sensitive and economical. However, an earlier polymer diaphragm revealed lower sensitivity than expected. In addition, the viscoelastic properties of polymer diaphragm have been considered to degrade the sensing performance due to a high-level mechanical noise. Here, we investigated the possibility of the polymer material as a MEMS microphone in terms of stiffness and damping. Stiffness was analyzed and experimentally verified. The obtained polymer diaphragm damping coefficient was compared with the coefficient of a silicon MEMS microphone to explore whether performance was degraded by material damping. All samples were fabricated using a thin film transfer method. SU-8 was mainly used but Polymethyl methacrylate (PMMA) was also selected for comparing the material damping effect. The measured residual stress of an SU-8 diaphragm was 18 MPa; the measured flexibility was similar to the state-of-art of a silicon-based MEMS microphone, and it was proven that there is room for further improvement through process optimization. The damping effect induced by viscoelasticity was very small, compared with the effect of air damping; indeed, the intrinsic damping effect of the polymer on device performance was negligible. [2021-0213]Keywords
Funding Information
- Tech Incubator Program for Startup (S2942669)
- Ministry of Small and Medium-sized Enterprises (SMEs) and Startups
This publication has 34 references indexed in Scilit:
- Thermoelastic damping of the axisymmetric vibration of circular plate resonatorsJournal of Sound and Vibration, 2009
- Squeeze film air damping in MEMSSensors and Actuators A: Physical, 2007
- Investigation of Solid-State Transitions in Linear and Crosslinked Amorphous Polymers2005
- An analytical model for support loss in micromachined beam resonators with in-plane flexural vibrationsSensors and Actuators A: Physical, 2003
- A simple deflection-testing method to determine Poisson s ratio for MEMS applicationsJournal of Micromechanics and Microengineering, 2002
- Mechanical Properties of Thin Films2002
- Large Deflections of Clamped Circular Plates Under Initial Tension and Transitions to Membrane BehaviorJournal of Applied Mechanics, 1998
- Mechanical-thermal noise in micromachined acoustic and vibration sensorsIEEE Transactions on Electron Devices, 1993
- Internal Friction in Solids II. General Theory of Thermoelastic Internal FrictionPhysical Review B, 1938
- Internal Friction in Solids. I. Theory of Internal Friction in ReedsPhysical Review B, 1937