Abstract
The presented studies are devoted to establishing the main patterns of stress state changes in the contact zone of the camshaft cam, the working surface of which is coated with an anti-friction coating. A method for studying the stress state of the cam working surface is proposed, which consists in selecting a calculation scheme that takes into account the operating conditions of the “cam-follower” connection, obtaining analytical dependencies for determining stresses in the contact zone, and their graphical interpretation to establish the main patterns. For the analytical study of the patterns of stress in the contact zone, the method of elasticity theory was used to solve contact problems. In this case, it was assumed that the cam and follower contact each other on a rectangular area. This made it possible to establish the main dependencies for determining the stress state in the studied zone. The calculation of circumferential and axial stresses made it possible to construct diagrams of their distribution for a cam with an anti-friction coating, as well as without an anti-friction coating. To analyze the causes of stress concentration peaks at the boundaries of the contact areas, calculations were made of the stress state of the cam surface, which is subjected only to friction stresses in the contact zone. Calculations of the stress state of the working surface of the camshaft of a KamAZ truck engine showed that compressive stresses arise in the circumferential direction, with their maximum reaching the central zone of the contact area. Tensile stresses are created at the edges of the contact area. It has been established that contact friction forces contribute to the appearance of stress peaks, the magnitude of which is related to the design features of the cam-follower friction pair of the camshaft. The calculations confirm the feasibility of using anti-friction coatings on the surfaces of camshaft cams. Applying such FANT coatings reduces stresses by 47% in the circumferential direction and 34% in the longitudinal direction, thereby reducing cam wear.