In situ evaluation of contact stiffness in a slip interface with different roughness conditions using ultrasound reflectometry
Open Access
- 10 November 2021
- journal article
- research article
- Published by The Royal Society in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
- Vol. 477 (2255) , 20210442
Abstract
Understanding the dynamic condition of the interface between a railway wheel and rail is important to reduce the risks and consider the effectiveness of countermeasures for tribological problems. Traditionally the difficulty in obtaining accurate non-destructive interfacial measurements has hindered systematic experimental investigations. Recently, an ultrasound reflectometry technique has been developed as a direct observation method of a rolling–sliding interface; however, the topography dependence under the high contact pressures in a wheel–rail contact has not been clarified. For this reason, a novel in situ measurement of the contact stiffness using ultrasound reflectometry was carried out for three different levels of roughness. A contact pressure equivalent to that in a wheel–rail interface was achieved by using a high-pressure torsion test approach. The dynamic change of contact stiffness with slip was measured using ultrasound and the influence of roughness was investigated. The measured changes were validated using a newly developed numerical simulation, and mechanisms to explain the observed behaviour were proposed in terms of fracture and plastic deformation of the asperity bonds. These findings could help in understanding the traction characteristics for different roughness conditions and also assist in understanding damage mechanisms better, such as wear and rolling contact fatigue.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/R001766/1)
This publication has 49 references indexed in Scilit:
- Contact stiffness of randomly rough surfacesScientific Reports, 2013
- An ultrasonic sensor for monitoring wheel flange/rail gauge corner contactProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2012
- Mapping railway wheel material wear mechanisms and transitionsProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2010
- Propagation of Sub-surface Cracks in Railway Wheels for Wear-induced Conformal ContactsJournal of Mechanical Systems for Transportation and Logistics, 2010
- Ultrasonic assessment of wheel—rail contact evolution exposed to artificially induced wearProceedings of the Institution of Mechanical Engineers, Part F: Journal of Rail and Rapid Transit, 2009
- The Effect of Lubricant on Microwear of Dull Rolls in Temper Rolling by 4 Hi Rolling MillISIJ International, 2009
- Development of Wheel/Rail Friction Moderating System (FRIMOS)Quarterly Report of RTRI, 2008
- Ultrasonic assessment of rough surface contact between solids from elastoplastic loading–unloading hysteresis cycleJournal of the Mechanics and Physics of Solids, 2004
- The ultrasonic pulse-echo technique as applied to adhesion testingJournal of Physics D: Applied Physics, 1973
- Friction Characteristics of Sliding Surfaces Undergoing Subsurface Plastic FlowJournal of Basic Engineering, 1960