Isolation design considerations for power supply of medium voltage silicon carbide gate drivers
- 1 October 2017
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2552-2559
Abstract
Single switch capable of blocking 10 kV and higher voltages are presently being developed and demand improved gate drivers for their functioning. Induction based gate drivers have been the foremost solutions in this regard. Design challenges that have been outlined for these drivers are low coupling capacitance, strong magnetic coupling and smaller dimensions with isolation not considered in depth. In this paper, first isolation requirements and its physical realization guidelines are provided from IEC 61800-5-1 for electric drives application. Based on study, two system insulation designs: single and double PCB are derived for lower MV and higher MV system respectively. Current loop gate driver with double PCB design is found to be practical and economical solution for higher MV power electronics systems. Afterwards, shortcomings of three state of art induction solutions at both system and magnetic link level is discussed. Improved transformers with primary MV cable providing mandatory solid insulation are fabricated. It is shown through impedance measurements that the cable has negative effect on the magnetizing inductance and coupling capacitance compared to state of art transformer solution. At the end, both set of transformers are tested with 64 kV impulse and 32 kV overvoltage with only improved transformers showing positive results.Keywords
This publication has 10 references indexed in Scilit:
- A new optically-isolated power converter for 12 V gate drive power supplies applied to high voltage and high speed switching devices2017
- Comparative performance evaluation of series connected 15 kV SiC IGBT devices and 15 kV SiC MOSFET devices for MV power conversion systems2017
- A galvanically isolated gate driver with low coupling capacitance for medium voltage SiC MOSFETs2016
- Design and evaluation of isolated gate driver power supply for medium voltage converter applications2016
- A Transformerless Intelligent Power Substation: A three-phase SST enabled by a 15-kV SiC IGBTIEEE Power Electronics Magazine, 2015
- 10 kV, 120 a SiC MOSFET modules for a power electronics building block (PEBB)2014
- Design considerations and development of gate driver for 15 kV SiC IGBT2014
- Comparison study of 12kV n-type SiC IGBT with 10kV SiC MOSFET and 6.5kV Si IGBT based on 3L-NPC VSC applications2012
- 10 kV, 120 A SiC half H-bridge power MOSFET modules suitable for high frequency, medium voltage applications2011
- Contactless energy transmission for an isolated 100W gate driver supply of a medium voltage converter2009