In Vivo Distribution of Spinal Intervertebral Stiffness Based on Clinical Flexibility Tests
- 15 January 2010
- journal article
- diagnostics
- Published by Wolters Kluwer Health in Spine
- Vol. 35 (2) , 186-193
Abstract
Study Design. A numerical study was conducted to identify the intervertebral stiffness of scoliotic spines from spinal flexibility tests. Objective. To study the intervertebral 3-dimensional (3D) stiffness distribution along scoliotic spine. Summary of Background Data. Few methods have been reported in literature to quantify the in vivo 3D intervertebral stiffness of the scoliotic spine. Based on the simulation of flexibility tests, these methods were operator-dependent and could yield to clinically irrelevant stiffnesses. Methods. This study included 30 patients surgically treated for severe idiopathic scoliosis. A previously validated trunk model, with patient-specific geometry, was used to simulate bending tests according to the in vivo displacements of T1 and L5 measured from bending test radiographs. Differences between in vivo and virtual spinal behaviors during bending tests (left and right) were computed in terms of vertebral rotations and translation. An automated method, driven by a priori knowledge, identified intervertebral stiffnesses in order to reproduce the in vivo spinal behavior. Results. Because of the identification of intervertebral stiffnesses, differences between in vivo and virtual spinal displacements were drastically reduced (95% of the differences less than ±3 mm for vertebral translation). Intervertebral stiffness distribution after identification was analyzed. On convex side test, the intervertebral stiffness of the compensatory curves increased in most cases, whereas the major curve became more flexible. Stiffness singularities were found in junctional zones: these specific levels were predominantly flexible, both in torsion and in lateral bending. Conclusion. The identification of in vivo intervertebral stiffness may improve our understanding of scoliotic spine and the relevance of patient-specific methods for surgical planning.Keywords
This publication has 20 references indexed in Scilit:
- 3D finite element simulation of Cotrel–Dubousset correctionComputer Aided Surgery, 2004
- Patient-specific mechanical properties of a flexible multi-body model of the scoliotic spineMedical & Biological Engineering & Computing, 2004
- Prospective Comparison of Flexibility Radiographs in Adolescent Idiopathic ScoliosisSpine, 2001
- Comparison of Push-Prone and Lateral-Bending Radiographs for Predicting Postoperative Coronal Alignment in Thoracolumbar and Lumbar Scoliotic CurvesSpine, 2000
- Traction Versus Supine Side BendingSpine, 1998
- Prediction of Correction of Scoliosis with Use of the Fulcrum Bending Radiograph*Journal of Bone and Joint Surgery, 1997
- Three-dimensional simulations of the scoliosis derotation maneuver with Cotrel-Dubousset instrumentationJournal of Biomechanics, 1994
- Three-Dimensional Simulation of Harrington Distraction Instrumentation for Surgical Correction of ScoliosisSpine, 1993
- Analog studies of forces in the human spine: Mechanical properties and motion segment behaviorJournal of Biomechanics, 1973
- Analog studies of forces in the human spine: Computational techniquesJournal of Biomechanics, 1973