6.4Gb/s multi-threaded BCH encoder and decoder for multi-channel SSD controllers
Authors:
- 1 February 2012
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- No. 01936530,p. 426-428
Abstract
Solid-state drives (SSDs), built with many flash memory channels, is usually connected to the host through an advanced high-speed serial interface such as SATA III associated with a transfer rate of 6Gb/s [1-2]. However, the performance of SSD is in general determined by the throughput of the ECC blocks necessary to overcome the high error-rate [3]. The binary BCH code is widely used for the SSD due to its powerful error-correction capability. As it is hard to achieve high-throughput strong BCH decoders [4-5], multiple BCH decoders are typically on a high-performance SSD controller, leading to a significant increase of hardware complexity. This paper presents an efficient BCH encoder/decoder architecture achieving a decoding throughput of 6Gb/s. The overall architecture shown in Fig. 25.3.1 includes a single BCH decoder and a multi-threaded BCH encoder. The single BCH encoder is responsible for all the channels and services a channel at a time in a round-robin manner.Keywords
This publication has 4 references indexed in Scilit:
- Low-Complexity Parallel Chien Search Structure Using Two-Dimensional OptimizationIEEE Transactions on Circuits and Systems II: Express Briefs, 2011
- 95%-lower-BER 43%-lower-power intelligent solid-state drive (SSD) with asymmetric coding and stripe pattern elimination algorithm2011
- A 26.9 K 314.5 Mb/s Soft (32400,32208) BCH Decoder Chip for DVB-S2 SystemIEEE Journal of Solid-State Circuits, 2010
- Hydra: A Block-Mapped Parallel Flash Memory Solid-State Disk ArchitectureIEEE Transactions on Computers, 2010