Analytical and Experimental Investigation of Thermocapillary Flow in Pulsed Laser Micropolishing
- 28 April 2014
- journal article
- Published by ASME International in Journal of Micro and Nano-Manufacturing
- Vol. 2 (2) , 021010
Abstract
The objective of this paper is to define and derive a dimensionless number as a function of material properties and process parameters to quantify the extent (magnitude) of thermocapillary flow in pulsed laser micropolishing (PLμP). Experimental work has shown that thermocapillary flow can tremendously reduce surface roughness (smoothing effect) although it inevitably introduces additional surface features (roughening effect) at the same time. Both the smoothing and roughening effects increase as the extent of thermocapillary flow increases. The extent of thermocapillary flow is the bridge from the available information (i.e., initial surface profile, material properties, and process parameters) to the polished surface profile to be predicted. A dimensionless number, called the normalized average displacement of a liquid particle in a single laser pulse, is proposed and derived via analytical heat transfer and fluid flow equations. The calculated normalized displacement is found to be proportional to the measured slope of the introduced features on Ti6Al4V surface polished with various process parameters, which indicates that the dimensionless number successfully describes the extent of thermocapillary flow. The normalized average displacement will be very useful for prediction of polished surface profile and hence parameter selection and process optimization in the future.Keywords
This publication has 13 references indexed in Scilit:
- Influence of overlap between the laser beam tracks on surface quality in laser polishing of AISI H13 tool steelJournal of Manufacturing Processes, 2012
- Pulsed laser micro polishing: Surface prediction modelJournal of Manufacturing Processes, 2012
- Temperature-dependent absorptance of painted aluminum, stainless steel 304, and titanium for 1.07 μm and 10.6 μm laser beamsOptics and Lasers in Engineering, 2012
- The Effect of Laser Pulse Duration and Feed Rate on Pulsed Laser Polishing of Microfabricated Nickel SamplesJournal of Manufacturing Science and Engineering, 2009
- Examination of Selective Pulsed Laser Micropolishing on Microfabricated Nickel Samples Using Spatial Frequency AnalysisJournal of Manufacturing Science and Engineering, 2009
- Heat transfer and fluid flow during keyhole mode laser welding of tantalum, Ti–6Al–4V, 304L stainless steel and vanadiumJournal of Physics D: Applied Physics, 2007
- Melting and dynamic-surface deformation in laser surface heatingInternational Journal of Heat and Mass Transfer, 2005
- Microroughness Reduction of Tungsten Films by Laser Polishing Technology with a Line BeamJapanese Journal of Applied Physics, 2004
- Surface modifications induced by ns and sub-ps excimer laser pulses on titanium implant materialBiomaterials, 2003
- Marangoni convection in weld pools with a free surfaceInternational Journal for Numerical Methods in Fluids, 1989