Failure investigation of fused deposition modelling parts fabricated at different raster angles under tensile and flexural loading
- 3 December 2015
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 231 (11) , 2031-2039
Abstract
Fused deposition modelling is an efficient rapid prototyping process used to rapidly fabricate three-dimensional solid objects with complicated geometries. Many process parameters affect the fused deposition modelling process and their settings influence the quality of the specimen. This article investigates the effect of raster angle on surface roughness (along and across the length direction) and mechanical properties (tensile and flexural strength) of fused deposition modelling parts built at 10 different raster angles (0°–90° at 10° interval). All parts are built using acrylonitrile butadiene styrene P430 material. Surface roughness for circular and parabolic curved surfaces is also measured when specimens are built at different raster angles. Fracture surfaces are inspected with scanning electron microscope to study the modes of failure under different loading conditions. The samples where raster angle is 0° and layers are deposited along the length of the specimen exhibited optimal mechanical strength and good surface finish (when measured along the length). Scanning electron microscope results reveal that for 0° raster angle, failures are mainly due to pulling and rupture of fibres and for 30° and 60° raster angle, failure is due to brittle shear in a direction parallel to raster orientation. Due to the presence of number of heating and cooling cycle in 90° raster orientation, interlayer cracking and distortion of raster take place leading to lower strength.Keywords
Funding Information
- All India Council for Technical Education (20/AICTE/RIFD/RPS (POLICY – III) 92/2012-13)
This publication has 18 references indexed in Scilit:
- An investigation on sliding wear of FDM built partsCIRP Journal of Manufacturing Science and Technology, 2012
- Build orientation analysis for minimum cost determination in FDMProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2011
- Parametric appraisal of mechanical property of fused deposition modelling processed partsMaterials & Design (1980-2015), 2010
- Representation of surface roughness in fused deposition modelingJournal of Materials Processing Technology, 2009
- Parametric appraisal of fused deposition modelling process using the grey Taguchi methodProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2009
- Optimization of rapid prototyping parameters for production of flexible ABS objectJournal of Materials Processing Technology, 2005
- Optimum part deposition orientation in fused deposition modelingInternational Journal of Machine Tools and Manufacture, 2004
- Analysis of the surface roughness and dimensional accuracy capability of fused deposition modelling processesInternational Journal of Production Research, 2002
- Critical parameters influencing the quality of prototypes in fused deposition modellingJournal of Materials Processing Technology, 2001
- Effect of Layer Orientation on Mechanical Properties of Rapid Prototyped SamplesMaterials and Manufacturing Processes, 2000