Rate-dependent tensile properties of paperboard and its plies
Authors:
Open Access
- 29 April 2024
- journal article
- research article
- Published by Walter de Gruyter GmbH in Nordic Pulp & Paper Research Journal
- Vol. 39 (3) , 349-358
Abstract
Tensile properties of paperboard have been characterized, and it has been shown that paper tensile properties are dependent on the strain rate. Tensile testing was done using strain rates in the range 10−4–3 s−1, which corresponds to crosshead movements ranging from 1 up to 24,000 mm/min, using an electro-mechanical testing machine. Two paperboards, and its free-laid top, middle and bottom plies were characterized in MD and CD. The testing was limited by the maximum crosshead speed of the testing machine. Initially 50 mm (grip to grip) long samples were tested, but to test even higher strain rates also short samples with length of 5 mm were tested. The results showed that ultimate strength increased by 9 % per decade increasing of testing rate, and Young’s modulus increased by 7 %. This shows that the previously reported rule of thumb of 10 % increase of in-plane strength per decade increase of strain rate holds. The testing here shows that this is valid also at strain rates as high as 3 s−1. Moreover, the strain at break in CD for long tensile specimens was observed to decrease when the strain rate exceeded 0.1 s−1, which resulted in straighter crack paths.Keywords
Funding Information
- Billerud
- Tetra Pak
This publication has 19 references indexed in Scilit:
- A rate-dependent continuum model for rapid converting of paperboardApplied Mathematical Modelling, 2021
- Novel Dynamic Test Methods for Paperboard Composite StructuresExperimental Techniques, 2021
- A Review of Recent Trends and Challenges in Computational Modeling of Paper and Paperboard at Different ScalesArchives of Computational Methods in Engineering, 2020
- High Strain Rate Mechanics of Polymers: A ReviewJournal of Dynamic Behavior of Materials, 2016
- An anisotropic in-plane and out-of-plane elasto-plastic continuum model for paperboardComposite Structures, 2015
- Experimental and numerical investigation of paperboard creasingProceedings in Applied Mathematics and Mechanics, 2014
- Quasi static analysis of creasing and folding for three paperboardsMechanics of Materials, 2014
- An experimental and computational study of laminated paperboard creasing and foldingInternational Journal of Solids and Structures, 2009
- Experimental and numerical studies of creasing of paperboardInternational Journal of Solids and Structures, 2009
- Review of experimental techniques for high rate deformation and shock studiesInternational Journal of Impact Engineering, 2004