Fabrication Techniques for PDMS Dome-Shaped Membrane Using Soft Lithography Process
- 31 October 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 660, 899-903
Abstract
The dome-shaped membrane is very important part of the micro/nano devices. The dome-shaped with the thickness of 150 μm and a radius of 3.2 mm was fabricated using the soft lithography process. The Polydimethylsiloxane (PDMS) was selected as a material because it deformable and suitable to implement as a membrane. Soft lithography is based on pattern transfer using a mold that is patterning the substrate material. In this paper, two techniques were suggested to fabricate the dome-shaped membrane which are reflow technique and stamping technique. The comparison was made for both techniques using a Scanning Electron Microscope (SEM) and it seems the stamping technique has an advantage where the uniform thickness of the dome-shaped membrane can be achieved. The discussion on the temperature effect of a stamping technique shows that the suitable temperature to harden the PDMS is in temperature room where the bubbles can be eliminated under this temperature.Keywords
This publication has 10 references indexed in Scilit:
- A dome shaped piezoelectric tactile sensor array using controlled inflation technique2013
- Modeling of Novel Microfluidic based Flow Sensor Inspired from Fish Canal Neuromast for Underwater SensingJurnal Teknologi (Sciences & Engineering), 2013
- Application of Microfluidic Device for Lactic BiosensorIEEE Sensors Journal, 2012
- Design and Fabrication of a PDMS/Parylene Microvalve for the Treatment of HydrocephalusJournal of Microelectromechanical Systems, 2011
- Integrated 3-D Silicon Electrodes for Electrochemical Sensing in Microfluidic Environments: Application to Single-Cell CharacterizationIEEE Sensors Journal, 2008
- Recent Developments in Polymer MEMSAdvanced Materials, 2007
- A Miniaturized Carbon Dioxide Gas Sensor Based on Sensing of pH-Sensitive Hydrogel Swelling with a Pressure SensorBiomedical Microdevices, 2005
- Dome shaped touch sensor using PZT thin film made by hydrothermal method2002
- Soft Lithography in Biology and BiochemistryAnnual Review of Biomedical Engineering, 2001
- SOFT LITHOGRAPHYAnnual Review of Materials Science, 1998