0.4-1 GHz Subsampling Mixer-First RF Front-End With 50-dB HRR, +10-dBm IB-IIP3 in 65-nm CMOS
- 5 May 2023
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 31 (7) , 1065-1077
Abstract
Reconfigurable subsampling mixer-first RF front-end is a potential candidate for low-power applications as it operates at a low clock frequency and hence consumes low power. However, the subsampling down-conversion has not been employed in mixer-first RF front-ends due to the disadvantage of high noise figure from inherent noise folding and lack of RF port impedance matching because of nonzero IF down-conversion. To address the above two issues, first, a subsampling multipath down-conversion mixer scheme is proposed for rejecting $3f_s/4$ and $5f_s/4$ down-conversions, thereby alleviating the effect of noise folding, leading to low noise figure. Second, an IF-stage impedance matching scheme is proposed that provides 50 $\Omega$ matching at the RF port of the mixer using an IF-LNA in shunt with an $M$ -phase switch-capacitor filter. The analysis of the proposed scheme in terms of noise figure, conversion gain, and harmonic rejection is presented. The proposed subsampling mixer-first RF front-end is implemented in 1.2 V, 65-nm CMOS technology. The prototype occupies an active area of 0.33 mm $^2$ , the switch-capacitor mixer and $M$ -phase filter consume 400 $\mu$ W of power, and IF amplifier and nonoverlapping clock generation circuit consume 25 mW and 6–12.6 mW of power, respectively. The RF front-end achieves a 6.5-dB noise figure, 15.1-dB conversion gain, 50-dB harmonic rejection ratio (HRR), and $+$ 10-dBm IB-IIP $_3$ .Keywords
This publication has 23 references indexed in Scilit:
- A Switched-Capacitor RF Front End With Embedded Programmable High-Order FilteringIEEE Journal of Solid-State Circuits, 2016
- A Fully-Integrated Reconfigurable Dual-Band Transceiver for Short Range Wireless Communications in 180 nm CMOSIEEE Journal of Solid-State Circuits, 2015
- Reconfigurable Receiver With Radio-Frequency Current-Mode Complex Signal Processing Supporting Carrier AggregationIEEE Journal of Solid-State Circuits, 2015
- A Low-Power, Low-Voltage WBAN-Compatible Sub-Sampling PSK Receiver in 65 nm CMOSIEEE Journal of Solid-State Circuits, 2014
- A 1.6GHz/4.8GHz dual-band CMOS fractional-N frequency synthesizer for S-Band radio applications2014
- Architectural Evolution of Integrated M-Phase High-Q Bandpass FiltersIEEE Transactions on Circuits and Systems I: Regular Papers, 2011
- Unified Frequency-Domain Analysis of Switched-Series-$RC$ Passive Mixers and SamplersIEEE Transactions on Circuits and Systems I: Regular Papers, 2010
- A 2.4-GHz RF sampling receiver front-end in 0.18-/spl mu/m CMOSIEEE Journal of Solid-State Circuits, 2005
- A Wideband 2.4-GHz Delta-Sigma Fractional->tex<$N$>/tex<PLL With 1-Mb/s In-Loop ModulationIEEE Journal of Solid-State Circuits, 2004
- The theory of bandpass samplingIEEE Transactions on Signal Processing, 1991