Microstructural Analysis of Liquid‐Phase‐Sintered β‐Silicon Carbide
Authors:
- Taketo SakumaTSTaketo Sakuma
- 1 February 2002
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 85 (2) , 430-436
Abstract
The microstructures of fine‐grained β‐SiC materials with α‐SiC seeds annealed either with or without uniaxial pressure at 1900°C for 4 h in an argon atmosphere were investigated using analytical electron microscopy and high‐resolution electron microscopy (HREM). An applied annealing pressure can greatly retard phase transformation and grain growth. The material annealed with pressure consisted of fine grains with β‐SiC as a major phase. In contrast, the microstructure in the material annealed without pressure consisted of elongated grains with half α‐SiC. Energy‐dispersive X‐ray analysis showed no differences in the amount of segregation of aluminum and oxygen atoms at grain boundaries, but did show a significant difference in the segregation of yttrium atoms at grain boundaries along SiC grains for the two materials. The increased segregation of yttrium ions at grain boundaries caused by the applied pressure might be the reason for the retarded phase transformation and grain growth. HREM showed a thin secondary phase of 1 nm at the grain boundary interface for both materials. The development of a composite grain consisting of a mixture of β/α polytypes during annealing was a feature common to both materials. The possible mechanisms for grain growth and phase transformation are discussed.Keywords
This publication has 30 references indexed in Scilit:
- Effect of Annealing Conditions on Microstructural Development and Phase Transformation in Silicon CarbideJournal of the American Ceramic Society, 2000
- Microstructural Control for Strengthening of Silicon Carbide CeramicsJournal of the American Ceramic Society, 1999
- In Situ Toughened Silicon Carbide with Al‐B‐C AdditionsJournal of the American Ceramic Society, 1996
- Toughness Properties of a Silicon Carbide with an in Situ Induced Heterogeneous Grain StructureJournal of the American Ceramic Society, 1994
- Effects of α‐Sic versus β‐Sic Starting Powders on Microstructure and Fracture Toughness of Sic Sintered with Al 2 O 3 ‐Y 2 O 3 AdditivesJournal of the American Ceramic Society, 1994
- In Situ‐Toughened Silicon CarbideJournal of the American Ceramic Society, 1994
- Mechanical properties of β-SiC pressureless sintered with Al2O3 additionsActa Metallurgica et Materialia, 1994
- Correlation between microstructure and mechanical properties in silicon carbide with alumina additionJournal of Materials Research, 1993
- Simple Calculation of SiC Polytype Contents from Powder X-Ray Diffraction PeaksJournal of the Ceramic Society of Japan, 1993
- Liquid Phase Sintering1985