Abstract
We performed a comparative study to find out the reasons why it is necessary to prepare the pure sulfide chalcopyrite, Cu(InGa)S2 (CIGS) under a Cu‐deficient condition to improve solar cell performance. It has been shown that CIGS that was grown under Cu‐deficient condition exhibits large open‐circuit voltage (VOC) boosting compared with that the one grown under Cu‐excess condition. Thus, CIGS were prepared from Cu‐excess and Cu‐deficient metal precursor (MP) and characterized concerning the origins of the different VOC. We observed that CIGS prepared using Cu‐excess MP suffered large recombination at buffer/CIGS interface and in bulk, which resulted in serious limitation of the VOC. On the other hand, CIGS prepared from Cu‐deficient MP exhibited largely improved VOC with reduced recombination. We conducted defect analysis using the photoluminescence (PL) method, and CIGS prepared using Cu‐excess MP exhibited strong deep emissions. However, CIGS prepared from Cu‐deficient MP exhibited PL emission characteristics without deep level transition. This implies that a large number of deep level defects exist in the CIGS prepared using Cu‐excess MP, and this might be the reason for the large recombination limiting VOC of the device. Finally, we also present the reason for deep levels in the CIGS prepared using Cu‐excess MP.
Funding Information
  • New Energy and Industrial Technology Development Organization

This publication has 17 references indexed in Scilit: