Single-Lap Joints of Similar and Dissimilar Adherends Bonded with an Acrylic Adhesive
- 15 May 2009
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 85 (6) , 351-376
Abstract
In this study, the tensile strength of single-lap joints (SLJs) between similar and dissimilar adherends bonded with an acrylic adhesive was evaluated experimentally and numerically. The adherend materials included polyethylene (PE), polypropylene (PP), carbon-epoxy (CFRP), and glass-polyester (GFRP) composites. The following adherend combinations were tested: PE/PE, PE/PP, PE/CFRP, PE/GFRP, PP/PP, CFRP/CFRP, and GFRP/GFRP. One of the objectives of this work was to assess the influence of the adherends stiffness on the strength of the joints since it significantly affects the peel stresses magnitude in the adhesive layer. The experimental results were also used to validate a new mixed-mode cohesive damage model developed to simulate the adhesive layer. Thus, the experimental results were compared with numerical simulations performed in ABAQUS®, including a developed mixed-mode (I+II) cohesive damage model, based on the indirect use of fracture mechanics and implemented within interface finite elements. The cohesive laws present a trapezoidal shape with an increasing stress plateau, to reproduce the behaviour of the ductile adhesive used. A good agreement was found between the experimental and numerical results.Keywords
This publication has 33 references indexed in Scilit:
- Modelling single and double-lap repairs on composite materialsComposites Science and Technology, 2005
- Adhesion performance of UHMWPE after different surface modification techniquesMedical Engineering & Physics, 2005
- Experimental investigation into the effect of DC glow discharge pretreatment of HDPE on tensile lap shear strengthInternational Journal of Adhesion and Adhesives, 2004
- An analytical solution for the analysis of symmetric composite adhesively bonded jointsComposite Structures, 2004
- Plasma jet treatment of five polymers at atmospheric pressure: surface modifications and the relevance for adhesionInternational Journal of Adhesion and Adhesives, 2004
- Application of interface finite elements to three‐dimensional progressive failure analysis of adhesive jointsFatigue & Fracture of Engineering Materials & Structures, 2003
- A Comparison of Corona-Treated and Flame-Treated Polypropylene FilmsPlasmas and Polymers, 2003
- Predicting Progressive Delamination of Stiffened Fibre-Composite Panel and Repaired Sandwich Panel by Decohesion ModelsJournal of Thermoplastic Composite Materials, 2002
- Characterisation and comparison of industrially pre-treated homopolymer polypropylene, HF 135MInternational Journal of Adhesion and Adhesives, 2002
- Three-dimensional finite element analysis of double-lap composite adhesive bonded joint using submodeling approachComposites Part B: Engineering, 1999