A 28-GHz class-J Power Amplifier with 18-dBm output power and 35% peak PAE in 120-nm SiGe BiCMOS
Authors:
- 1 January 2014
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 71-73
Abstract
A 28-GHz Power Amplifier (PA) designed in 120-nm SiGe BiCMOS for potential use in mobile millimeter-wave phased arrays is presented in this paper. The core of the PA is a cascode amplifier operated in class-J mode. A multi-harmonic load-pull analysis was used to determine the optimum harmonic output impedances (up to third harmonic) resulting in improved efficiency. The PA has a measured 15.3-dB small signal gain, 18.6-dBm saturated output power and 35.3% peak power added efficiency (PAE) at 28GHz. At 1-dB compression the PA has a 15.5-dBm output power and 31.5% PAE.Keywords
This publication has 6 references indexed in Scilit:
- Highly Efficient Saturated Power AmplifierIEEE Microwave Magazine, 2012
- An introduction to millimeter-wave mobile broadband systemsIEEE Communications Magazine, 2011
- Class-J RF power amplifier with wideband harmonic suppression2011
- A Methodology for Realizing High Efficiency Class-J in a Linear and Broadband PAIEEE Transactions on Microwave Theory and Techniques, 2009
- Reliability of SiGe HBTs for Power Amplifiers—Part I: Large-Signal RF Performance and Operating LimitsIEEE Transactions on Device and Materials Reliability, 2009
- Algorithmic Design of CMOS LNAs and PAs for 60-GHz RadioIEEE Journal of Solid-State Circuits, 2007