3D Spacer Fabric Structure for the Prevention and Care of Pressure Ulcers
Open Access
- 1 December 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 213512-213521
Abstract
Many pressure wound protection products, such as pressure redistribution supports and exuding wound dressings, are made of polyurethane sponge. However, polyurethane sponge does not possess a desirable combination of air permeability, moisture management and mechanical properties required by pressure redistribution supports and exuding wound dressings. This study explores the optimization of a 3D warp-knitted spacer fabric (WKSF) structure for pressure ulcer protection. The influence of construction and material parameters on the compression performance and air permeability of WKSFs was investigated by numerical simulation and then validated with experiments. The moisture transport and wetting properties of WKSFs were characterized by a moisture management tester. The numerical simulation and experimental results indicate that the WKSF structure can be tuned to achieve compressional properties, air permeability, and moisture management performance that are more suitable for pressure ulcer protection than polyurethane sponge. WKSFs constructed with a low-density surface layer, coarser spacer yarns, and larger spacer yarn inclination-angle are more suitable for pressure redistribution support surfaces, while WKSFs constructed with dense surface layers and coarse spacer yarn can better meet the performance requirements of exuding wound dressings.Keywords
Funding Information
- National Natural Science Foundation of China (51903199)
- Natural Science Basic Research Program of Shaanxi (2018JQ5214, 2019JQ-182)
- Scientific Research Program Funded by Shaanxi Provincial Education Department (18JS039)
This publication has 18 references indexed in Scilit:
- Pressure ulcer and wounds reporting in NHS hospitals in England part 1: Audit of monitoring systemsJournal of Tissue Viability, 2016
- Analysis of structure of warp-knitted spacer fabric on pressure indicesFibers and Polymers, 2015
- Bodily Pain Intensity in Nursing Home Residents With Pressure Ulcers: Analysis of National Minimum Data Set 3.0Research in Nursing & Health, 2015
- Exploring use of warp-knitted spacer fabric as a substitute for the absorbent layer for advanced wound dressingTextile Research Journal, 2014
- Influence of porosity on water vapor permeability behavior of warp knitted polyester spacer fabricsJournal of Industrial Textiles, 2014
- Microclimate and development of pressure ulcers and superficial skin changesInternational Wound Journal, 2013
- Investigation on the impact and compression-after-impact properties of warp-knitted spacer fabricsTextile Research Journal, 2012
- Compression behavior of warp-knitted spacer fabrics for cushioning applicationsTextile Research Journal, 2011
- A Functional Fabric for Pressure Ulcer PreventionTextile Research Journal, 2009
- Formation of the Scab and the Rate of Epithelization of Superficial Wounds in the Skin of the Young Domestic PigNature, 1962