Liquid-phase deposition of Al2O3 coating on quartz fiber for enhanced strength at elevated temperature
- 17 September 2021
- journal article
- research article
- Published by Taylor & Francis in Composite Interfaces
- Vol. 29 (5) , 487-501
Abstract
In the manuscript, the liquid-phase deposition technique was used to successfully deposit an Al2O3 ceramic coating on the quartz fiber. The thickness of the coating was not uniform. The thickest part of the coating can reach to 1159 nm. The main coating formed is Al2O3, but there are still hydrous Al(OH)3. With the extension of the deposition time, the micro-morphology of the coating changed from nano-scale clusters to dense flakes. The coating had an amorphous structure. In this case, the coating effectively improved the mechanical properties of the quartz fiber at high temperatures, and the breaking load of the fiber increased with the extension of the deposition time. After high temperature annealing, the breaking load of the coated fiber deposited for 6 h was 126.1 N, compared to 50.3 N of the blank fiber. The protection mechanism of Al2O3 coating was studied from the aspect of microstructure. By observing the surface morphologies of blank fiber and coated fiber after high temperature annealing. It was found that the presence of the coating hindered the damage of the fiber surface by high temperature, and the defects on the fiber surface were reduced, so the mechanical properties were effectively improved. Graphical AbstractKeywords
Funding Information
- the Key Field R & D Program of Guangdong Province (2019B090908004)
This publication has 15 references indexed in Scilit:
- Experimental and theoretical analysis of curvature sensor based on cladding mode resonance with triple cladding quartz specialty fiberOptics Communications, 2018
- Preparation of a flexible high emissivity coating on quartz fiber fabric for thermal protectionCeramics International, 2017
- Room-temperature aqueous plasma electrolyzing Al2O3 nano-coating on carbon fiberApplied Surface Science, 2017
- Surface modification of quartz fibres for dental composites through a sol-gel processMaterials Science and Engineering: C, 2017
- Waveform shaping of 1550 nm transmission through hollow quartz fiberOptik, 2014
- Effect of different thickness h-BN coatings on interface shear strength of quartz fiber reinforced SiOCN compositeApplied Surface Science, 2014
- Fabrication and characterization of ceramic coatings with alumina–silica sol-incorporated α-alumina powder coated on woven quartz fiber fabricsCeramics International, 2013
- Mechanical properties and microstructure of 3D orthogonal quartz fiber reinforced silica composites fabricated by silicasol-infiltration-sinteringMaterials & Design (1980-2015), 2012
- Effect of moderately high temperature heat treatment on surface morphology and structure of quartz fibersApplied Surface Science, 2012
- The effect of SiO2-doped boron nitride multiple coatings on mechanical properties of quartz fibersApplied Surface Science, 2012