Techno-economic analysis and life cycle assessment for catalytic fast pyrolysis of mixed plastic waste
Top Cited Papers
Open Access
- 5 June 2023
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in Energy & Environmental Science
- Vol. 16 (9) , 3638-3653
Abstract
Pyrolysis of waste plastics has gained interest as a candidate chemical recycling technology. To examine the potential of this approach, we conducted a techno-economic analysis (TEA) and life cycle assessment (LCA) of a conceptual catalytic fast pyrolysis (CFP) facility that converts 240 metric tons/day of mixed plastic waste. The modeled base case predicts the minimum selling price (MSP) of a benzene, toluene, and xylenes (BTX) mixture at $1.07/kg when co-products are sold at their average market prices. We predict that the aromatic product stream can be cost-competitive with virgin BTX mixtures ($0.68/kg) if the mixed waste plastics are available for less than $0.10/kg or if crude oil prices exceed $60/barrel. Moreover, we estimate that CFP-based conversion of waste plastics can reduce the total supply chain energy use by 24% but with a 2.4-fold increase in greenhouse gas (GHG) emissions per kilogram of BTX, relative to incumbent manufacturing process. Sensitivity analysis highlights that feedstock cost, co-product selling prices, capital cost for product separations, and operating costs are key cost drivers. Further, we examine three additional CFP processes that differ in product composition, namely naphtha, and a case where the products are rich in either C2–C4 olefins or BTX aromatic hydrocarbons. Whereas the MSP of naphtha ($2.18/kg) is ~4-fold higher than virgin naphtha, both the olefin-rich and aromatics-rich product cases exhibit a potential reduction in MSP up to 40%, with a 21%–45% reduction in total supply chain energy and 2.2–3.8-fold increase in GHG emissions relative to incumbent manufacturing processes. LCA predicts that the CFP process exhibits lower fossil fuel depletion than virgin manufacturing across all cases as well as lower acidification, ozone depletion, and smog formation for select cases, but high utility and feedstock preparation requirements result in poorer performance across other metrics. Overall, this study highlights important process parameters for improving CFP of mixed waste plastics from economic and environmental perspectives.Keywords
Funding Information
- U.S. Department of Energy (DE-AC36-08GO28308)
This publication has 85 references indexed in Scilit:
- Renewable Chemical Commodity Feedstocks from Integrated Catalytic Processing of Pyrolysis OilsScience, 2010
- Pyrolysis of Mixed Plastic Wastes for the Recovery of Benzene, Toluene, and Xylene (BTX) Aromatics in a Fluidized Bed and Chlorine Removal by Applying Various AdditivesEnergy & Fuels, 2009
- Catalytic degradation of plastic waste into petrochemicals using Ga-ZSM-5Fuel, 2008
- Evolution with the Temperature of the Compounds Obtained in the Catalytic Pyrolysis of Polyethylene over HUSYIndustrial & Engineering Chemistry Research, 2008
- Hydroprocessing catalysts regeneration and recyclingApplied Catalysis A: General, 2007
- Characteristics of liquid product from the pyrolysis of waste plastic mixture at low and high temperatures: Influence of lapse time of reactionWaste Management, 2007
- Yield and Composition of Gases and Oils/Waxes from the Feedstock Recycling of Waste Plastic2006
- TraciJournal of Industrial Ecology, 2002
- Maximization of FCC light olefins by high severity operation and ZSM-5 additionCatalysis Today, 2000
- Some observations on the recycling of plastics and rubberConservation & Recycling, 1977