Investigation of Friction Coefficient at Stack Compression Tests
Open Access
- 17 April 2026
- journal article
- Published by Trans Tech Publications, Ltd. in Solid State Phenomena
- Vol. 390, 173-180
Abstract
During sheet metal forming (for example, deep drawing), the desired geometry is typically produced under large plastic deformations. However, in order to characterize the material behavior in this deformation range as accurately as possible, experimental investigation of the material is indispensable. Such investigations are necessary, among other reasons, to determine material properties that may later serve as input parameters for finite element (FEM) simulations. By defining appropriate material properties, the design and optimization of the forming technology become more efficient. One such property is the material’s flow curve; for determining it in the large deformation range, a particularly promising method is the stack compression test (SCT). At the same time, the method also has certain drawbacks. One is that the test is not standardized, and therefore there is no exact methodology for its execution. Another difficulty arises from the fact that the friction conditions present during the test are not clearly defined. In this paper, we seek to determine whether the friction conditions in the case of the SCT can be inferred by a comparative analysis of experimental force–displacement curves and force–displacement curves obtained from FEM simulations.Keywords
This publication has 11 references indexed in Scilit:
- Verification of flow curve determination from plane strain compression testsCIRP Journal of Manufacturing Science and Technology, 2025
- A pathway to refined stress and strain distributions in aerospace-grade Ti/Al bi-metal sheets: Synergizing theoretical insights and FEM simulationsChinese Journal of Aeronautics, 2024
- Large strain flow curve identification for sheet metalJournal of Materials Processing Technology, 2022
- Effect of hydrostatic stress on the strength differential effect in low-carbon steel sheetInternational Journal of Material Forming, 2022
- Contact pressure-dependent friction characterization by using a single sheet metal compression testWear, 2021
- Influence of a Hydrostatic Pressure Shift on the Flow Stress in Sheet MetalProcedia Manufacturing, 2020
- FEM Investigation of Ductile Fracture Prediction in Two-Point Incremental Sheet Metal Forming processProcedia Engineering, 2017
- Influence of the pressure dependent coefficient of friction on deep drawing springback predictionsTribology International, 2016
- A method for the layer compression test considering the anisotropic material behaviorInternational Journal of Material Forming, 2009
- Analytical and experimental study of frictional behavior in through-thickness compression testJournal of Materials Processing Technology, 2005