Enhancing auxetic gradient structures for hip joint implants to optimize stress shielding reduction
Open Access
- 11 October 2024
- journal article
- research article
- Published by IOP Publishing in Physica Scripta
- Vol. 99 (11) , 115941
Abstract
This study investigates the design and optimization of a porous hip implant to mitigate stress shielding. Initially, the focus was on determining the elastic modulus of a three-dimensional auxetic structure, primarily in the y-direction. Various methods—numerical, analytical, and experimental—were used to assess the elastic properties. Additive manufacturing was employed to create samples, which were then tested for their elastic properties through compression testing. The results revealed a strong correlation between the elastic modulus values obtained from simulations and experimental tests in the y-direction. To further enhance the implant’s performance and reduce stress shielding at the implant-bone interface, a gradient structure was introduced. This gradient design progressively increases the elastic modulus away from the bone contact surfaces, aligning closely with the bone’s modulus at the interface. The elastic modulus of this gradient structure was computed using Abaqus software and validated through analytical methods in MATLAB, with a minimal 4.8% difference between the two approaches, demonstrating high agreement. The application of a genetic algorithm enabled the creation of a porous hip implant tailored to minimize stress shielding throughout its structure. This innovative approach, integrating numerical, analytical, and experimental techniques with gradient structures, holds promise for improving hip implant performance and enhancing patient outcomes by reducing stress-shielding complications.Keywords
This publication has 37 references indexed in Scilit:
- Mechanical Properties of 2D Re-Entrant Gradient Structures Produced by Additive ManufacturingIranian Journal of Science and Technology, Transactions of Mechanical Engineering, 2024
- Experimental study of energy absorption capability in the lattice structures based on the octagonal bipyramid unit cellJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2023
- Improving Mechanical Properties and Energy Absorption of Additive Manufacturing Lattice Structure by Struts’ Node StrengtheningActa Mechanica Solida Sinica, 2022
- Introducing the new lattice structure based on the representative element double octagonal bipyramidAerospace Science and Technology, 2022
- Architectural bone parameters and the relationship to titanium lattice design for powder bed fusion additive manufacturingAdditive Manufacturing, 2021
- 3D printed three-dimensional metallic microlattices with controlled and tunable mechanical propertiesAdditive Manufacturing, 2021
- Topological design, permeability and mechanical behavior of additively manufactured functionally graded porous metallic biomaterialsActa Biomaterialia, 2019
- Mechanical Properties and Microstructure of Mg-SiCp Composite Sheets Fabricated by Sintering and Warm RollingJournal of Materials Engineering and Performance, 2017
- Additive Manufacturing of Metal Cellular Structures: Design and FabricationJOM, 2015
- Compressive properties of Ti–6Al–4V auxetic mesh structures made by electron beam meltingActa Materialia, 2012