Development of a calibration chamber for a novel in situ testing device
Open Access
- 18 February 2026
- journal article
- Published by Emerald Publishing in International Journal of Physical Modelling in Geotechnics
- Vol. 26 (5) , 240-249
Abstract
The paper presents the design of a calibration chamber, developed for the testing of a novel self-burrowing probe for in situ soil investigation. The self-burrowing probe is currently under development at ETH Zurich, and its key components will be proof-tested in the controlled environment of the developed chamber. The design of the latter incorporates specific solutions for the testing of the probe: the chamber is equipped with a central opening at the top and base plates, enabling the probe to vertically protrude from the chamber. This aspect is useful for eliminating the tip resistance of the probe and isolating its response, which is relevant when assessing the resistance of the probe’s anchoring system or, in general, for the evaluation of interface properties. The chamber allows for testing under two boundary conditions: (i) zero lateral strain or (ii) constant lateral stress. In the latter case, the radial stress is applied by water pressure inside a membrane, while a pneumatic, doughnut-shaped cushion at the base is used to impose the vertical stress. The paper outlines the key components of the chamber, the sample preparation, and the testing procedures, along with the results of the proof tests conducted in dry Perth sand.Keywords
Funding Information
- Swiss National Science Foundation (200021_188459)
This publication has 20 references indexed in Scilit:
- Modeling the self-penetration process of a bio-inspired probe in granular soilsBioinspiration & Biomimetics, 2021
- SBOR: a minimalistic soft self-burrowing-out robot inspired by razor clamsBioinspiration & Biomimetics, 2020
- Evaluation of self-penetration potential of a bio-inspired site characterization probe by cavity expansion analysisCanadian Geotechnical Journal, 2020
- Compressive and Tensile Shaft Resistance of Nondisplacement Piles in SandJournal of Geotechnical and Geoenvironmental Engineering, 2019
- Undrained Behavior of Sand–Structure Interfaces Subjected to Cyclic Torsional ShearingJournal of Geotechnical and Geoenvironmental Engineering, 2018
- Razor clam to RoboClam: burrowing drag reduction mechanisms and their robotic adaptationBioinspiration & Biomimetics, 2014
- Submarine Mass Movements and Their Consequences2011
- Development of a new calibration chamber for conducting cone penetration tests in unsaturated soilsCanadian Geotechnical Journal, 2011
- Evaluation of Relative Density and Shear Strength of Sands from CPT and DMT2003
- Calibration Chamber Size Effects on Penetration Resistance in SandJournal of Geotechnical and Geoenvironmental Engineering, 1998