Realization of Multiple Concurrent Beams With Independent Circular Polarizations by Holographic Reflectarray
- 13 June 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Antennas and Propagation
- Vol. 66 (9) , 4627-4640
Abstract
A multibeam radiator with each beam possessing independent polarization is developed by a single-feed holographic reflectarray (RA) antenna without using any optimization algorithms. Regardless of wave polarization, the relation between the electromagnetic properties of the antenna aperture (henceforth referred to as “hologram”) and impinging wave properties can be described by the holographic technique. For the practical implementation of such a hologram, we used a subwavelength metallic patch with anisotropic properties to satisfy the input admittance distribution of the hologram. In doing so, a fast numerical method, fundamentally inspired by the method of moments, is employed to calculate the input admittance of the element for all angles of incidence. This technique significantly speeds up the design process. Finally, as a typical case, a simple circularly polarized RA with four-beam radiation pattern was manufactured and tested at 13 GHz. The measured results showed that the aperture efficiency of 45.8%, cross-polarization discrimination of higher than 25 dB, 1 dB drop gain, 3 dB axial ratio bandwidths of 19.23% and 18.26%, sidelobe level of below -17 dB, and peak gain of around 19.43 dBi for each beam were obtained.Keywords
Funding Information
- Iran University of Science and Technology
This publication has 28 references indexed in Scilit:
- A Single-Layer Dual-Band Circularly Polarized Reflectarray With High Aperture EfficiencyIEEE Transactions on Antennas and Propagation, 2015
- Reflectarray Design With Similarity-Shaped Fragmented Sub-Wavelength ElementsIEEE Transactions on Antennas and Propagation, 2014
- Accurate method for synthesis of shaped‐beam non‐uniform reflectarray antennaIET Microwaves, Antennas & Propagation, 2013
- Efficient numerical tool for the analysis and design of reflectarrays based on cells with three parallel dipolesMicrowave and Optical Technology Letters, 2013
- Phase error analysis of the effect of feed movement on bandwidth performance of a broadband X-Ku band reflectarrayInternational Journal of RF and Microwave Computer-Aided Engineering, 2012
- TRANSMISSION LINE MODELING AND NUMERICAL SIMULASION FOR THE ANALYSIS AND OPTIMUM DESIGN OF METAMATERIAL MULTILAYER STRUCTURESProgress In Electromagnetics Research B, 2009
- Analysis of multilayered printed frequency selective surfaces by the MoM/BI-RME methodIEEE Transactions on Antennas and Propagation, 2003
- Efficient Computation of Generalized Scattering Matrix for Analyzing Multilayered Periodic StructureIEEE Transactions on Antennas and Propagation, 1995
- Babinet's Principle for an Anisotropic Resistive Surface Using Different ApproachesOptica Acta: International Journal of Optics, 1986
- Electromagnetic scattering of an arbitrary plane wave by a wire mesh with bonded junctionsCanadian Journal of Physics, 1976