Operational level for unconditional release of contaminated property from affected areas around Fukushima Daiichi nuclear power plant
Authors:
Open Access
- 17 June 2013
- journal article
- research article
- Published by Oxford University Press (OUP) in Radiation Protection Dosimetry
- Vol. 157 (3) , 446-454
Abstract
This paper focuses on the surface contamination control of slightly contaminated property after the Fukushima nuclear accident. The operational level for the unconditional release of contaminated properties is calculated in counts per minute (cpm) to enable the use of a typical Geiger-Muller (GM) survey meter with a 50-mm bore, on the basis of the surficial clearance level of 10 Bq cm−2 for 134Cs and 137Cs derived in the previous studies of the authors. By applying a factor for the conversion of the unit surface contamination to the count rate of a survey meter widely used after the Fukushima accident, the operational level for the unconditional release of contaminated properties was calculated to be 2300 cpm on average and 23 000 cpm at the highest-contamination part. The calculated numerical values of the operational levels are effective as long as the typical GM survey meter is used in the radiation measurement.Keywords
This publication has 13 references indexed in Scilit:
- Food safety regulations: what we learned from the Fukushima nuclear accidentJournal of Environmental Radioactivity, 2012
- Safety regulations of food and water implemented in the first year following the Fukushima nuclear accidentJournal of Radiation Research, 2012
- Radiological protection from radioactive waste management in existing exposure situations resulting from a nuclear accidentRadiation Protection Dosimetry, 2012
- Verification of screening level for decontamination implemented after Fukushima nuclear accidentRadiation Protection Dosimetry, 2012
- Results of Simplified Survey for Thyroid Internal Exposure of Children in Fukushima and Other SurveysJapanese Journal of Health Physics, 2012
- Validity of generic scenarios used in derivation of exemption levels for surface contamination considering transport-specific aspectsRadiation Protection Dosimetry, 2011
- Tokai-1 Decommissioning ProjectJapanese Journal of Health Physics, 2010
- Calculation of isotope-specific exemption levels for surface contaminationApplied Radiation and Isotopes, 2009
- Verification of Validity of Isotope-Specific Exemption Levels for Surface Contamination Using Monte Carlo CalculationJapanese Journal of Health Physics, 2009
- Particle and gas dry deposition: A reviewAtmospheric Environment (1967), 1980