Parameter selection for aeroengine transient state gas path analysis
Open Access
- 1 July 2022
- journal article
- research article
- Published by Global Power and Propulsion Society in Journal of the Global Power and Propulsion Society
- Vol. 6, 61-73
Abstract
Compared with steady state data, engine transient state data cover a wider working scope of components, more complex operating conditions, and therefore can provide more abundant information regarding engine health status. To make the fullest use of engine transient data, this paper presents the methods on how to choose the proper measurements and health parameters when constructing an aeroengine gas path analysis system. The measurement selection based on sensitivity analysis is conducted, compared to which an effortless measurement selection method termed Minimum Identifiability Loss (MIL) is proposed. Aiming to reduce the estimation uncertainty, the analysis of maximal linearly independent group is presented to select optimal health parameters under the condition of limited measurements. Finally, the component health status identifiability analysis base on transient data also gives a good explanation to gas path analysis “smearing effect”.Keywords
This publication has 12 references indexed in Scilit:
- Measurement Selection for Engine Transients by Parameter SignaturesJournal of Engineering for Gas Turbines and Power, 2010
- Application of the Systematic Sensor Selection Strategy for Turbofan Engine Diagnostics2008
- The Fisher Information Matrix as a Relevant Tool for Sensor Selection in Engine Health MonitoringInternational Journal of Rotating Machinery, 2008
- Gas turbine component fault detection from a limited number of measurementsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2004
- Assessment of the Effectiveness of Gas Path Diagnostic SchemesJournal of Engineering for Gas Turbines and Power, 2004
- Parameter selection for diagnosing a gas-turbine's performance-deterioration : Ogaji, S. O. T. et al. Applied Energy, 2002, 73, (1), 25–46Fuel and Energy Abstracts, 2003
- Identifiability in Multi-Point Gas Turbine Parameter Estimation Problems2002
- Non-Linear Engine Component Fault Diagnosis From a Limited Number of Measurements Using a Combinatorial Approach2002
- Optimal Measurement and Health Index Selection for Gas Turbine Performance Status and Fault DiagnosisJournal of Engineering for Gas Turbines and Power, 1992
- Parameter Selection for Multiple Fault Diagnostics of Gas Turbine EnginesJournal of Engineering for Power, 1975