KYKun Yang

Kun Yang

*This is an algorithmically generated author record based on publicly available information.

Kun Yang has a total of 14 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A probabilistic approach for aero-engine component performance margins design

    by Kun Yang, Yanghui Sun, Zhiyong Tan, Naixian Hou, Xu Pan

    Uncertainties in the design and manufacturing processes may lead the overall performance of individual engines deviate from their original design, posing a risk of failing to meet intended performance requirements. Traditional empirical methods often fail to provide appropriate component performance margins and tend to assign overly conservative margins, which exacerbates the difficulty of achieving overall performance matching. To address the problem of component performance margin design under specific aero-engine performance success rate requirements, a novel approach is proposed based on neural network and global optimization algorithm, within the framework of the Monte Carlo simulation (MCS). The approach utilizes benchmark commercial software to generate a large amount of structured data to train a multi-layer perceptron (MLP) model, thereby obtaining a surrogate model for the impact of component performance variation on overall performance under engine design condition, and then combines the MLP model with a differential evolution algorithm (DE) to carry out the component performance margin design. The results show that the coefficient of determination ( R 2 ) and the p -value for the constructed MLP model are both 1.00, with a maximum relative error of only 0.052% compared to the benchmark model outputs. The proposed margin design approach increases the engine performance success rate from the original 44.31% to the target of 99.00%, with a computation time of approximately only 10 seconds. The extended case study considering both design and off-design conditions further demonstrates the robustness of the proposed method.

  • Open Access

    Parameter selection for aeroengine transient state gas path analysis

    by Kun Yang, Qiuye Tu, Yunhao Zeng, Jing Xuan

    Compared with steady state data, engine transient state data cover a wider working scope of components, more complex operating conditions, and therefore can provide more abundant information regarding engine health status. To make the fullest use of engine transient data, this paper presents the methods on how to choose the proper measurements and health parameters when constructing an aeroengine gas path analysis system. The measurement selection based on sensitivity analysis is conducted, compared to which an effortless measurement selection method termed Minimum Identifiability Loss (MIL) is proposed. Aiming to reduce the estimation uncertainty, the analysis of maximal linearly independent group is presented to select optimal health parameters under the condition of limited measurements. Finally, the component health status identifiability analysis base on transient data also gives a good explanation to gas path analysis “smearing effect”.


  • Open Access

    Design of a multifunction novel flexible fault current limiter for AC distribution network

    by Yao Liu, Lin Guan, Zhe Tan, Kun Yang, Fang Guo, Yong Chen, Renliang Liu, Feng Zheng

    Based on the separation voltage type of cascaded H bridge-modular multilevel converters (CHB-MMC) and current predictive model control (CPMC) technology, a novel flexible fault-current limiter (NFFCL) is firstly proposed for restraining the negative impact of the distribution network’s disturbance in this paper. When a disturbance occurs, the inner-loop CPMC of the multilevel converters establish the value function to offer the specific current, thus increasing the voltage deviation at both ends of the series capacitor or generating reverse harmonic compensation voltage. In that case, three single-phase MNFFCLs can be regarded as variable voltage sources to eliminate the negative effects of faults or harmonics. Owing to the multi-capacitance series structure, the maximum voltage drops of the single capacitance can be predetermined by the number of capacitors. And with the low voltage drop of single capacitance, the output current of the CHB-MMC can also be controlled within an acceptable range. Through the simulation results, the disturbance’s negative impact on the non-fault area can be eliminated almost 100%.