Residual Stress, Mechanical Properties, and Grain Morphology of Ti-6Al-4V Alloy Produced by Ultrasonic Impact Treatment Assisted Wire and Arc Additive Manufacturing
Open Access
Abstract
Ultrasonic Impact Treatment (UIT) is an effective technique for surface refinement and residual stress reduction, which is widely used in welding. This study investigates UIT-assisted Wire and Arc Additive manufacturing (WAAM). The residual stress, grain morphology and mechanical properties of post-UIT and as-deposited samples are studied. The result demonstrates that the UIT has a significant influence on the decrease of the residual stress. Moreover, the residual stress of the post-UIT samples is much lower than that of the as-deposited samples. The samples fabricated by UIT-assisted WAAM have a novel, bamboo-like distribution of prior-β grains, an alternating distribution of short columnar grains and equiaxed grains. The grain size of this bamboo-like structure is much smaller than the coarsen columnar grains. In addition, the mechanical properties of the post-UIT and as-deposited samples are compared. The results indicate that the average tensile strength of the post-UIT samples is higher, while the average elongation of the post-UIT samples is lower.Keywords
This publication has 22 references indexed in Scilit:
- Wire-feed additive manufacturing of metal components: technologies, developments and future interestsThe International Journal of Advanced Manufacturing Technology, 2015
- Stress relaxation due to ultrasonic impact treatment on multi-pass weldsScience and Technology of Welding and Joining, 2014
- Microstructure and residual stress improvement in wire and arc additively manufactured parts through high-pressure rollingJournal of Materials Processing Technology, 2013
- A computationally efficient finite element model of wire and arc additive manufactureThe International Journal of Advanced Manufacturing Technology, 2013
- Low cycle fatigue behavior of laser melting deposited TC18 titanium alloyTransactions of Nonferrous Metals Society of China, 2013
- Enhanced fatigue durability of Al–6 Mg alloy by applying ultrasonic impact peening: Effects of surface hardening and reinforcement with AlCuFe quasicrystalline particlesMaterials Science and Engineering: A, 2013
- Dry sliding wear behavior of laser clad TiVCrAlSi high entropy alloy coatings on Ti–6Al–4V substrateMaterials & Design (1980-2015), 2012
- Thermo-mechanical analysis of Wire and Arc Additive Layer Manufacturing process on large multi-layer partsComputational Materials Science, 2011
- Rapid tooling: selective laser sintering injection toolingJournal of Materials Processing Technology, 2003
- RAPID MANUFACTURING AND RAPID TOOLING WITH LAYER MANUFACTURING (LM) TECHNOLOGIES, STATE OF THE ART AND FUTURE PERSPECTIVESCIRP Annals, 2003