Ship hull in-water cleaning and its effects on fouling-control coatings
Open Access
- 15 March 2020
- journal article
- research article
- Published by Taylor & Francis in Biofouling
- Vol. 36 (3) , 332-350
Abstract
Today, ship hull fouling is managed through fouling-control coatings, complemented with in-water cleaning. During cleaning, coating damage and wear must be avoided, for maximum coating lifetime and reduced antifoulant release. When possible, cleaning should target early stages of fouling, using minimal forces. However, such forces, and their effects on coatings, have not yet been fully quantified. In this one-year study, minimal cleaning forces were determined using a newly-designed immersed waterjet. The results show that bi-monthly/monthly cleaning, with maximum wall shear stress up to ∼1.3 kPa and jet stagnation pressure ∼0.17 MPa, did not appear to cause damage or wear on either the biocidal antifouling (AF) or the biocide-free foul-release (FR) coatings. The AF coating required bi-monthly cleanings to keep fouling to incipient slime (time-averaged results), while the FR coating had a similar fouling level even without cleaning. The reported forces may be used in matching cleaning parameters to the adhesion strength of the early stages of fouling.Keywords
This publication has 42 references indexed in Scilit:
- Economic impact of biofouling on a naval surface shipBiofouling, 2010
- The use of proactive in-water grooming to improve the performance of ship hull antifouling coatingsBiofouling, 2010
- Effects of coating roughness and biofouling on ship resistance and poweringBiofouling, 2007
- Laboratory screening of coating libraries for algal adhesionBiofouling, 2007
- A methodology for evaluating biocide release rate, surface roughness and leach layer formation in a TBT-free, self-polishing antifouling coatingBiofouling, 2006
- Improved estimates of environmental copper release rates from antifouling productsBiofouling, 2006
- Copper emissions from antifouling paint on recreational vesselsMarine Pollution Bulletin, 2004
- Variation in adhesion strength ofBalanus eburneus, crassostrea virginicaandhydroides dianthusto fouling‐release coatingsBiofouling, 2001
- A turbulent channel flow apparatus for the determination of the adhesion strength of microfouling organismsBiofouling, 2000
- The testing and evaluation of non‐toxic antifouling coatingsBiofouling, 1996