Identification of Corrosion on a Hollow Tube Using Vibration
- 6 June 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Applied Mechanics and Materials
- Vol. 564, 176-181
Abstract
Vibration based technique have so far been focused on the identification of structural damage. However, not many studies have been conducted on the corrosion identification on pipes. The objective of this paper is to identify corrosion on pipes from vibration measurements. A hollow pipe, 500 mm in length with 63.5 mm in diameter was subjected to impact loading using an impact hammer to identify the natural frequency of the tube in two conditions i) without any corrosion and ii) with an induced localized 40 mm by 40 mm corrosion at the middle of the pipe. The shift of natural frequencies of the structures under free boundary conditions was examined for each node of excitation. The results showed that there is a shift in natural frequency of the pipe, between 3 and 4 Hz near to the corrosion area. It can suggested that that the impact vibration is capable of identifying of localized corrosion on a hollow tube.Keywords
This publication has 4 references indexed in Scilit:
- Techniques for corrosion monitoring2008
- Steel consumption and economic growth: Evidence from IndiaResources Policy, 2006
- Pipe failure probability—the Thomas paper revisitedReliability Engineering & System Safety, 2000
- Flexural vibrations of the walls of thin cylindrical shells having freely supported endsProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1949