Abstract
The choice of the Cr–Ni–Mo alloying system for high (450–550 HB) and ultra-high (> 600 HB) hardness steels, taking into account the influence of silicon (Si) and aluminum (Al) on the properties depending on the thickness of the protective elements of the struc¬ture is substantiated. To decrease steel intensity of the protection system against high-energy impacts, it is sufficient to use plates with a thickness of 20 mm and the maxi¬mum silicon content in the steel is of priority to ensure its surface hardness. It is shown that for t < 20 mm, an increased Si content is advisable to ensure high surface hard¬ness, while for t > 20 mm the through-hardenability and impact toughness are determining factors. This is achieved by an increased Al content due to the grain refinement of austenite. The influence of the Al/Si content ratio on the combination of mechanical pro¬perties and microstructure stability, in particular in the heat-affected zone of welded joints, is analyzed. The need for a differentiated approach to choosing an alloying system and optimizing the Al/Si content ratio in accordance with the thickness of the protective struc¬tural elements and expected failure mechanisms is substantiated.

This publication has 8 references indexed in Scilit: