From Monolayer MoS2 FETs to MoS2−MoO2 Nanoheterostructures: Enhanced Self-Powered Visible-Light and NO2 Sensing
- 23 October 2026
- journal article
- Published by American Chemical Society (ACS) in ACS Applied Nano Materials
- Vol. 9 (44) , 20731-20742
Abstract
Self-powered multifunctional sensors require internal fields that can separate photocarriers and transduce surface adsorption events without continuous external bias. Here, we show that chemical vapor deposition (CVD) growth conditions can tune the morphology of nanostructured molybdenum disulfide (MoS2), forming sulfur-deficient quadrilateral flakes with coexisting molybdenum-sulfur (Mo−S) and molybdenum-oxygen (Mo−O) chemical environments, consistent with MoS2−MoO2 (MSMO) phase coexistence. Comprehensive structural, optical, and chemical characterization confirms the distinct growth regimes of monolayer, few-layer, dendritic, and quadrilateral flake and verifies the morphology and composition of the resulting phases. Devices fabricated from pristine MoS2, gate-modulated MoS2, and the MSMO quadrilateral-flake film were compared under visible illumination and NO2 exposure. The monolayer MoS2 FET exhibits n-type gate modulation with an on/off ratio of ∼ 4 − 7, field-effect mobility of ∼0.2−0.7 cm2V−1s−1, threshold voltage of ∼1.5 − 3.1 V, and subthreshold swing of ∼5 − 8 V.dec−1, indicating conventional but weakly gate-controlled CVD MoS2 transistor behavior. The heterostructure device outperforms the monolayer MoS2 FET device, delivering responsivity of 100 A/W, detectivity of 1012 Jones (at 630 nm, 30 mW optical power), response/recovery times of 200 ms, and operation over the visible spectrum at zero bias. The same junction architecture also enables room-temperature NO2 sensing with a sub-ppm (∼0.1 PPM) limit of detection (LOD) at a low bias of 0.5 V, and this decreases further with illumination. The device exhibits a zero-bias sensing response with a few ppm LOD (∼5 ppm), whereas pristine MoS2 control devices require a higher applied bias and exhibit weaker modulation. Thus, internal interface field enables a faster and measurable self-powered photodetection and NO2 sensing than external electrostatic gating.Keywords
Funding Information
- Ministry of Electronics and Information technology
- Nano Mission Council
- Ministry of Education, India
- Science and Engineering Research Board (CRG/2022/006973)
This publication has 60 references indexed in Scilit:
- Two-dimensional inorganic materials for next-generation sensors and energy systems: comparative insights into graphene, silicene, and boropheneJournal of Materials Science: Materials in Electronics, 2026
- PEDOT:PSS: borophene and P3HT: borophene nanocomposites for multi-gas detectionJournal of Materials Science: Materials in Electronics, 2026
- High‐Performance Self Powered Broadband Photodetection in Graphene‐Contacted MoTe 2 /WS 2 van der Waals Heterostructures via Interfacial Band EngineeringSmall, 2025
- Native Oxide MoO₂– MoSe₂ Heterostructure‐Based Self‐Powered Gas Sensor for Selective NO₂ and H₂ DetectionSmall, 2025
- Recent Progress in 2D Heterostructures for High‐Performance Photodetectors and Their ApplicationsAdvanced Optical Materials, 2025
- Self‐Powered Broadband Photodetectors Based on WS2‐Anchored MoS2 with Enhanced Responsivity and DetectivitySmall, 2025
- A Photovoltaic Self‐Powered Gas Sensor Based on All‐Dry Transferred MoS2/GaSe Heterojunction for ppb‐Level NO2 Sensing at Room TemperatureAdvanced Science, 2021
- High Surface Area MoS2/Graphene Hybrid Aerogel for Ultrasensitive NO2 DetectionAdvanced Functional Materials, 2016
- From Bulk to Monolayer MoS2: Evolution of Raman ScatteringAdvanced Functional Materials, 2012
- Resolving surface chemical states in XPS analysis of first row transition metals, oxides and hydroxides: Cr, Mn, Fe, Co and NiApplied Surface Science, 2011