Synthesis and characterization of RF-sputtered ZnTe/Cu 2− x Te thin films for solar cell applications
Open Access
- 31 July 2026
- journal article
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 17 (1) , 1016-1027
Abstract
The incorporation of copper and oxygen into zinc telluride (ZnTe) thin films deposited by radio-frequency magnetron sputtering from a single ZnTe–CuO composite target was investigated. The nominal Cu and O concentrations ranged from 3 to 13 atom %, and films were grown at substrate temperatures of 300 and 350 °C. Energy-dispersive X-ray spectroscopy confirmed controlled compositional transfer from the target to the films. X-ray diffraction analysis revealed that all films are polycrystalline, exhibiting a coexistence of zinc blende and wurtzite ZnTe phases. Low dopant concentrations produced only minor lattice modifications, while higher Cu and O contents promoted the formation of Cu 2− x Te secondary phases, as confirmed by Raman spectroscopy, grazing-incidence X-ray diffraction and scanning electron microscopy. Optical measurements showed a significant reduction in infrared transmittance with increasing Cu concentration, attributed to the metallic-like absorption of Cu 2− x Te phases. Electrical characterization revealed a transition from semiconducting to highly conductive behavior with resistivity decreasing from approximately 10 2 to 10 −2 Ω·cm for films grown at 300 °C and from 10 1 to 10 −3 Ω·cm for films grown at 350 °C. Simultaneously, the carrier concentration increased from approximately 10 17 to 10 21 cm −3 and the mobility from 10 −1 to 10 1 cm 2 ·V −1 ·s −1 . These results indicate that structural, optical, and electrical properties of ZnTe are primarily influenced by Cu incorporation and the formation of conductive Cu-rich secondary phases, yielding a biphasic system composed of semiconducting ZnTe and conductive Cu-rich telluride phases. These material properties suggest potential relevance for future studies of back-contact materials in CdTe-based solar cells.Keywords
This publication has 43 references indexed in Scilit:
- Comprehensive Study of Carrier Recombination in High‐Efficiency CdTe Solar Cells Using Transient PhotovoltageSolar RRL, 2024
- Thickness and annealing evolution to physical properties of e-beam evaporated ZnTe thin films as a rear contact for CdTe solar cellsJournal of Materials Science: Materials in Electronics, 2021
- Solar cell efficiency tables (Version 58)Progress in Photovoltaics: Research and Applications, 2021
- Structural, optical and magnetic properties of cobalt-doped ZnTe dilute magnetic semiconductorsJournal of Materials Science: Materials in Electronics, 2020
- Material and Si-based diode analyses of sputtered ZnTe thin filmsJournal of Materials Science: Materials in Electronics, 2020
- Effect of vacuum annealing on structural and optical properties of nanocrystalline ZnTe thin filmsJournal of Materials Science: Materials in Electronics, 2017
- CuTe Nanoparticles/Carbon Nanotubes as Back Contact for CdTe Solar CellsJournal of Electronic Materials, 2017
- Optical Characteristics of ZnTeO Thin Films Synthesized by Pulsed Laser Deposition and Molecular Beam EpitaxyJournal of Electronic Materials, 2008
- Effect of substrate temperature on the structural, optical and electrical properties of vacuum-evaporated ZnTe filmsMaterials Letters, 1992
- Optimization of growth conditions for ZnTe filmsMaterials Letters, 1983