Gerardo Arreola Jardón
Research Subjects
Gerardo Arreola Jardón has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Aime Gutiérrez-Peralta
Facultad de Ciencias Químicas, Universidad Autónoma de Querétaro, Querétaro 76017, Mexico
1 shared publication - Claudia Elena Pérez García
Facultad de Química, Universidad Autónoma de Querétaro, Cerro de las Campanas, Santiago de Querétaro 76010, Querétaro, Mexico
1 shared publication - Sergio Jimenez-Sandoval
Centro de Investigación y de Estudios Avanzados del Instituto Politécnico Nacional, Unidad Querétaro, Libramiento Norponiente No. 2000, Real de Juriquilla, Querétaro, Qro. 76230, Mexico
1 shared publication - Susana Meraz Dávila
Universidad Politécnica de Santa Rosa Jáuregui, Querétaro 76220, Mexico
1 shared publication
Latest Publications
- Open Access
- 31 July 2026
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 17 (1) , 1016-1027
Synthesis and characterization of RF-sputtered ZnTe/Cu 2− x Te thin films for solar cell applications
The incorporation of copper and oxygen into zinc telluride (ZnTe) thin films deposited by radio-frequency magnetron sputtering from a single ZnTe–CuO composite target was investigated. The nominal Cu and O concentrations ranged from 3 to 13 atom %, and films were grown at substrate temperatures of 300 and 350 °C. Energy-dispersive X-ray spectroscopy confirmed controlled compositional transfer from the target to the films. X-ray diffraction analysis revealed that all films are polycrystalline, exhibiting a coexistence of zinc blende and wurtzite ZnTe phases. Low dopant concentrations produced only minor lattice modifications, while higher Cu and O contents promoted the formation of Cu 2− x Te secondary phases, as confirmed by Raman spectroscopy, grazing-incidence X-ray diffraction and scanning electron microscopy. Optical measurements showed a significant reduction in infrared transmittance with increasing Cu concentration, attributed to the metallic-like absorption of Cu 2− x Te phases. Electrical characterization revealed a transition from semiconducting to highly conductive behavior with resistivity decreasing from approximately 10 2 to 10 −2 Ω·cm for films grown at 300 °C and from 10 1 to 10 −3 Ω·cm for films grown at 350 °C. Simultaneously, the carrier concentration increased from approximately 10 17 to 10 21 cm −3 and the mobility from 10 −1 to 10 1 cm 2 ·V −1 ·s −1 . These results indicate that structural, optical, and electrical properties of ZnTe are primarily influenced by Cu incorporation and the formation of conductive Cu-rich secondary phases, yielding a biphasic system composed of semiconducting ZnTe and conductive Cu-rich telluride phases. These material properties suggest potential relevance for future studies of back-contact materials in CdTe-based solar cells.
- 31 July 2026
- Published by Beilstein Institut in Beilstein Journal of Nanotechnology
- Vol. 17 (1) , 1016-1027
Open AccessSynthesis and characterization of RF-sputtered ZnTe/Cu 2− x Te thin films for solar cell applications
The incorporation of copper and oxygen into zinc telluride (ZnTe) thin films deposited by radio-frequency magnetron sputtering from a single ZnTe–CuO composite target was investigated. The nominal Cu and O concentrations ranged from 3 to 13 atom %, and films were grown at substrate temperatures of 300 and 350 °C. Energy-dispersive X-ray spectroscopy confirmed controlled compositional transfer from the target to the films. X-ray diffraction analysis revealed that all films are polycrystalline, exhibiting a coexistence of zinc blende and wurtzite ZnTe phases. Low dopant concentrations produced only minor lattice modifications, while higher Cu and O contents promoted the formation of Cu 2− x Te secondary phases, as confirmed by Raman spectroscopy, grazing-incidence X-ray diffraction and scanning electron microscopy. Optical measurements showed a significant reduction in infrared transmittance with increasing Cu concentration, attributed to the metallic-like absorption of Cu 2− x Te phases. Electrical characterization revealed a transition from semiconducting to highly conductive behavior with resistivity decreasing from approximately 10 2 to 10 −2 Ω·cm for films grown at 300 °C and from 10 1 to 10 −3 Ω·cm for films grown at 350 °C. Simultaneously, the carrier concentration increased from approximately 10 17 to 10 21 cm −3 and the mobility from 10 −1 to 10 1 cm 2 ·V −1 ·s −1 . These results indicate that structural, optical, and electrical properties of ZnTe are primarily influenced by Cu incorporation and the formation of conductive Cu-rich secondary phases, yielding a biphasic system composed of semiconducting ZnTe and conductive Cu-rich telluride phases. These material properties suggest potential relevance for future studies of back-contact materials in CdTe-based solar cells.