Investigation of Losses in Fingers and Clamping Plates of High-Power Electrical Machines
Authors:
- 5 September 2022
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2187-2192
Abstract
When designing an electrical machine, the losses in end-regions are often neglected or approximated with empirical equations due to the complexity of the involved physical phenomena and the difficulty to measure them. As a consequence, important differences can appear between the total measured losses and the value predicted by the analytic tools. This error can result in a high economic loss for machine manufacturers. This paper presents a 3D FEM eddy current loss calculation in fingers and clamping plates of an experimental bench set up. The study focuses on the effect of the axial component of the flux density at the end region on these losses in the case of different materials and power supply frequencies. Simulations results are presented and analyzed.Keywords
Funding Information
- Association Nationale de la Recherche et de la Technologie
This publication has 6 references indexed in Scilit:
- A Fast Calculation Approach for Pressure Finger Losses in Large Salient-Pole Synchronous MachinesIEEE Transactions on Magnetics, 2021
- A Novel Surface Impedance Based Clamping Plate Loss Model for Large Synchronous Generators2019
- Development and validation of an electrical and magnetic characterization device for massive parallelepiped specimensInternational Journal of Applied Electromagnetics and Mechanics, 2019
- 3-D Finite Element Method Analysis of Additional Load Losses in the End Region of Permanent-Magnet GeneratorsIEEE Transactions on Magnetics, 2012
- 3-D Finite Element Analysis of Additional Eddy Current Losses in Induction MotorsIEEE Transactions on Magnetics, 2012
- Three dimensional finite element analysis of stator clamp plate losses of large turbo-generators2002