Splitting Failures in Trapezoidal Steel Roof Cladding
Authors:
- 1 February 2004
- journal article
- Published by American Society of Civil Engineers (ASCE) in Journal of Performance of Constructed Facilities
- Vol. 18 (1) , 4-11
Abstract
High wind events such as hurricanes and storms often cause severe damage to crest-fixed thin steel roof claddings. Past research on wind damage has shown that low cycle fatigue cracking of steel roof sheeting around the fastener holes has been the reason for the premature pull-through failures of roof claddings under fluctuating wind forces. Such a situation will be at its worst if the roof sheeting is already split at the fastener holes. An inspection of trapezoidal steel roofs has shown that roofing has been split in the transverse direction due to overtightening of screw fasteners accidental or caused by poor workmanship. Once split, even slightly, the roofing can survive only a few cycles of wind uplift loading. Therefore an investigation using laboratory experiments and finite element analyses was carried out to study the splitting behavior of two commonly used high tensile steel trapezoidal roof claddings. The analytical and experimental results agree reasonably well and present a good understanding...Keywords
This publication has 3 references indexed in Scilit:
- Pull-over Strength of Trapezoidal Steel Claddings1999
- Wind-Resistant Low-Rise Buildings in the TropicsJournal of Performance of Constructed Facilities, 1995
- Behaviour and design of crest-fixed profiled steel roof claddings under wind upliftEngineering Structures, 1994