Design and Analysis of a Five-Phase SPM Machine Considering Third Harmonic Current Injection
- 7 March 2018
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Energy Conversion
- Vol. 33 (3) , 1108-1117
Abstract
This paper analytically derives the optimal 3rd harmonic current to improve the output torque in five-phase surface-mounted permanent magnet (SPM) machines under the constraints of the same peak/rms value. The relationship between the output torque and the 3rd harmonic current is established and its optimal value for maximizing the output torque is derived. It is found that the optimal 3rd harmonic current is dependent on the ratio of the third harmonic back-EMF to the fundamental one but it is not 1/6 of the fundamental one as pulse width modulation in inverter. In order to improve the output torque by increasing the fundamental and third harmonic winding factors, and the third harmonic airgap flux density, the unequal width tooth and permanent magnet (PM) segmentation are employed in the 10-slot/8-pole five-phase SPM machine. The optimal unequal tooth dimensions and the number of PM segmentations are analyzed for maximizing the output torque. The airgap flux density, back-EMF, cogging torque and output torque of the machine with equal/unequal tooth width and unsegmented/segmented PM are compared. Finally, the experiments on the prototype 10-slot/8-pole PM machine with unequal tooth width and segmented rotor are given to verify the analytical and FE analyses.Keywords
Funding Information
- National Natural Science Foundation of China (51607089)
- Natural Science Foundation of Jiangsu Province (BK20150744)
- Fundamental Research Funds for the Central Universities (NE2016003)
This publication has 20 references indexed in Scilit:
- Analytical Modeling of Modular and Unequal Tooth Width Surface-Mounted Permanent Magnet MachinesIEEE Transactions on Magnetics, 2015
- Torque Improvement of Five-Phase Surface-Mounted Permanent Magnet Machine Using Third-Order HarmonicIEEE Transactions on Energy Conversion, 2014
- Design optimization of a high performance five-phase slotless PMSM2014
- Effect of the number magnet-segments on the output torque and the iron losses of a SMPM2013
- Torque Density Improvement of Five-Phase PMSM Drive for Electric Vehicles ApplicationsJournal of Power Electronics, 2011
- Eleven-phase induction machine: steady-state analysis and performance evaluation with harmonic injectionIET Electric Power Applications, 2010
- A high-torque low-speed multiphase brushless machine-a perspective application for electric vehiclesIEEE Transactions on Industrial Electronics, 2002
- Torque density improvement in a six-phase induction motor with third harmonic current injectionIEEE Transactions on Industry Applications, 2002
- Analysis and simulation of five-phase synchronous reluctance machines including third harmonic of airgap MMFIEEE Transactions on Industry Applications, 1998
- Analysis of a concentrated winding induction machine for adjustable speed drive applications. II. Motor design and performanceIEEE Transactions on Energy Conversion, 1991