In situ Lithiated ALD Niobium Oxide for Improved Long Term Cycling of Layered Oxide Cathodes: A Thin-Film Model Study
Authors:
- Abdessalem AribiaAAAbdessalem Aribia
- Jordi SastreJSJordi Sastre
- Xubin ChenXCXubin Chen
- Evgeniia GilshteinEGEvgeniia Gilshtein
- Ayodhya N. TiwariATAyodhya N. Tiwari
- Yaroslav E. RomanyukYRYaroslav E. Romanyuk
Preprint
- 26 March 2021
- preprint
- Published by American Chemical Society (ACS) in ChemRxiv
Abstract
Protective coatings applied to cathodes help to overcome interface stability issues and extend the cycle life of Li-ion batteries. However, within 3D cathode composites it is difficult to isolate the effect of the coating because of the additives and non-ideal interfaces. In this study we investigate niobium oxide (NbO x ) as cathode coating in a thin-film model system, which provides simple access to the cathode-coating-electrolyte interface. The conformal NbO x coating was applied by atomic layer deposition (ALD) onto thin-film LiCoO 2 cathodes. The cathode/coating stacks were annealed to lithiate the NbO x and ensure sufficient ionic conductivity. A range of different coating thicknesses were investigated to improve the electrochemical cycling with respect to the uncoated cathode. At a NbO x thickness of 30 nm, the cells retained 80% of the initial capacity after 493 cycles at 10 C, more than doubling the cycle life of the uncoated cathode film. At the same thickness, the coating also showed a positive impact on the rate performance of the cathode: 47% of the initial capacity was accessible even at ultrahigh charge-discharge rates of 100 C. Using impedance spectroscopy measurements, we found that the enhanced performance is due to suppressed interfacial resistance growth during cycling. Elemental analysis using TOF-SIMS and XPS further revealed a bulk and surface contribution of the NbO x coating. These results show that in situ lithiated ALD NbO x can significantly improve the performance of layered oxide cathodes by enhancing interfacial charge transfer and inhibiting surface degradation of the cathode, resulting in better rate performance and cycle life.Keywords
All Related Versions
- Published version: Journal of the Electrochemical Society, 168 (4), 040513.