Design of the semi-closed die for shaping the thick coin-like carbon steel parts in a single operation
Open Access
- 6 June 2023
- journal article
- research article
- Published by Springer Nature in SN Applied Sciences
- Vol. 5 (7) , 1-11
Abstract
The current study strives to improve the precision and accuracy of a die and reduce unnecessary production steps. Upset cold forging for thick coin-like carbon steel parts were studied and redesigned for a single operation. The slug used in this experiment was an annealed AISI 1020 carbon steel bar sheared into cylinders having a height to diameter ratio (h0/d0) of 2.07. The design problem is to prevent an inclined slug surface due to surface roughness when it is loaded in the die cavity. The redesigned die is semi-closed with a fixed support at a position 0.25 of the initial height of the slug. Six springs were employed to set the start-to-finish position during forging. The results showed that slugs with rough and uneven surfaces, with an h0/d0ratio of 2.07, could successfully undergo a single forging. Furthermore, the upset forged coin was designed to have a straight 2.4 mm outer edge, providing area for a set of mechanical fingers to grasp the workpiece during transfer to subsequent steps in the work process of a vertical and/or horizontal forging die set.Keywords
Funding Information
- Rajamangala University of Technology Isan (10/2561)
- Khon Kaen University
This publication has 28 references indexed in Scilit:
- Forgebility evaluation of SNCM 220 steel by warm compression test and microstructure behaviors characteristicsInternational Journal of Precision Engineering and Manufacturing-Green Technology, 2016
- Analysis of forging defects for selected industrial die forging processesEngineering Failure Analysis, 2016
- Quick prediction of the folding defect in transitional region during isothermal local loading forming of titanium alloy large-scale rib-web component based on folding indexJournal of Materials Processing Technology, 2015
- Rational parameters of profiled workpieces for an upsetting processThe International Journal of Advanced Manufacturing Technology, 2014
- On the anisotropic deformation of AZ31 Mg alloy under compressionMaterials & Design (1980-2015), 2011
- Preform design for forging and extrusion processes based on geometrical resemblanceProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 2010
- Some aspects of barrelling in elliptical shaped billets of aluminium during cold upset forging with lubricantMaterials & Design (1980-2015), 2008
- Experimental investigation of the forming parameters of the rotational upset forging processJournal of Materials Processing Technology, 2001
- The net-shape forming of gearsMaterials & Design (1980-2015), 2000
- Analysis and prevention of cracking phenomenon occurring during cold forging of two AISI 1010 steel pulleysMetallurgical and Materials Transactions A, 1999