The simulation of influence of engagement conditions and technological teeth correction on contact strength, wear and durability of cylindrical spur gear of electric locomotive
Authors:
- 5 August 2016
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology
- Vol. 231 (1) , 57-62
Abstract
The cylindrical spur tractive gear of the electric locomotive has been conducted using the author’s method of the calculation of maximum contact pressures, teeth wear and durability at technological correction of engagement at changeable, in the result of teeth wear and conditions of their contact. The regularities of tribocontact pressures change in engagement has been established after reaching the permissible wear depending on the shift coefficients in the phases of double–single–double tooth engagement. Considerable decrease of maximum tribocontact pressures is observed in the result of teeth wear in the entry phase of double-tooth engagement in comparison with their initial values. Depending on the shift coefficients, maximum (permissible) wear of wheel teeth would arise in different contact points: at the entrance into single-tooth engagement in non-corrected gear and at the exit in the presence of correction. Gear durability has its optimum at = 0.1 which is 1.22 times larger than in the absence of engagement correction.
Keywords
This publication has 11 references indexed in Scilit:
- A method for the evaluation of the influence of correction and wear of the teeth of a cylindrical gear on its durability and strength. Part 1. Service life and wearMaterials Science, 2012
- Generalized method for the evaluation of wear in cylindrical involute gearsMaterials Science, 2011
- An Ease-Off Based Method for Loaded Tooth Contact Analysis of Hypoid Gears Having Local and Global Surface DeviationsJournal of Mechanical Design, 2010
- Influence of Tooth Profile Deviations on Helical Gear WearJournal of Mechanical Design, 2004
- Simulation of wear in gears with flank interference—a mixed FE and analytical approachWear, 2003
- A simplified model for wear prediction in helical gearsWear, 2001
- Simulation of mild wear in helical gearsWear, 2000
- Contact problems of gears using Overhauser splinesInternational Journal of Mechanical Sciences, 1999
- Wear simulation of spur gearsTribotest, 1999
- Simulation of mild wear in spur gearsWear, 1997