Statistical Investigation of Maintenance Effects on Quality of Formed Glass Tube Dimensions
- 1 April 2015
- journal article
- Published by Trans Tech Publications, Ltd. in Defect and Diffusion Forum
- Vol. 362, 108-114
Abstract
Process quality control utilizes inspection of a product while it is being produced through testing periodic samples of products. After this, if product quality characteristics have been changed, the process is stopped, and a search is made for an assignable cause. The objective of a process-capability study is to assess the ability of a process to meet product specifications. During a quality improvement initiative, capability-estimates are obtained at start and at end of study to reflect the occurred improvement. Several capability-estimates show how a process is capable of meeting its specification limits. Essentially, capability-estimates reflect the non conformance rate of a process in a single number form. This involves calculating some ratio of process specification limits. In this study, the production of a fluorescent lamp consisting of a glass tube is considered. Tube quality is affected by the production line conditions. So, the maintenance of the production line is an important stage to increase tube quality. In this paper glass tube quality is studied. Minitab is a statistical software was used to analyze obtained data. The results showed an obvious improvement of part quality after maintenance stage. All measurements were done in Toshiba factory for fluorescent lamp manufacturing.Keywords
This publication has 7 references indexed in Scilit:
- Integrating the continuous improvement of measurement systems into the statistical quality control of manufacturing processes: A novel linkCIRP Annals, 2012
- A comparison of the performance of statistical quality control charts in a dairy production system through stochastic simulationAgricultural Systems, 2005
- The Six Sigma Handbook Revised and Expanded: A Complete Guide for Greenbelts, Blackbelts, and Managers at All LevelsThe TQM Magazine, 2004
- Statistical quality control and social processes: A drug testing applicationSocio-Economic Planning Sciences, 1997
- Statistical quality control and improvementEuropean Journal of Operational Research, 1996
- The relevance of research on statistical process control to the total quality movementJournal of Engineering and Technology Management, 1993
- Quality control & inspection: Knowledge-based quality control systemComputers & Industrial Engineering, 1988